Serviettenapkin Folding Simple Standing Fan Recipes

SERVIETTE/NAPKIN FOLDING, SIMPLE FAN VARIATION

Steps:

• Lay your serviette square out flat before you.
• Take the bottom right and left corners and make an accordion fold strips all the way up to the top right and left corners. If you press these with an iron the pleats will be nice and sharp. Leave unironed for a wavy casual look. (but ironed looks neater) You will now have a thin band the width of your accordion fold.
• Fold the serviette in half so that is is now half it's length and slip a serviette ring over the fold end of the accordion strip and pull gently about 1 inch ( 2.5 cm) up.
• Fan out the accordion pleats at the top to make a pleasing balance to the serviette. Present on a plate.

SERVIETTE NAPKIN FOLDING , BASIC WITH NAPKIN RING

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the origonal square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing downwards. We will call this the South corner, and the top corner opposite North.
• Grasp your serviette about 2/3 of the ways up and starting at point that is on the East side of your serviette, make 5 folds or pleats more or less the same size, folding/ pleating towards from the East point to the West point.
• Slip your Serviette Ring over the north point and gently pull downwards so that only the top 1/3 of the serviette goes though the ring. Keep the north point of the serviette nicely centered.
• Spread the bottom half out the serviette into a fan formation so that both halves are equal and it looks pleasingly balanced.The top of the serviette should taper gently up to the North point and if wanted a small flower can be inserted into the fold at the top and down into the napkin ring.
• Place on empty plate.

SERVIETTE/NAPKIN FOLDING, SIMPLE STANDING FAN

Steps:

• Lay your serviette out flat and square before you.
• Take the top and bottom left hand corners and fold them over to the top and bottom right hand corners so that you now have a vertical rectangle before you, with the crease on the left.
• Starting at the bottom left and bottom right corners, accordion fold the serviette upwards to just past the half way point of the rectangle. (ironing the folds helps them to keep their shape).
• Now take the right side corner edge of the accordion folded strip and fold it over to the left side corner edge of the accordion strip so that the strip is now folded in half. There will be a square shape that is folded in half hanging out at the back.
• Holding the folded accordion pleats firmly, take hold of the top right corner of the square flap at the back (this corner has two open points, no fold line) and fold it over to meet the bottom left point of the square (right next to the accordion fold where it is folded in half), it should overlap the bottom of the square just a little.
• Now take that little overlapping flap and tuck it under the bottom of the square, that should secure things so that the serviette will stand up well.
• Carefully stand the serviette up and fan out the accordion pleats, the square part will be at right angles out at the back and stabilizes the fan as it stands up.
• Present it standing on a plate.

SERVIETTE/NAPKIN FOLDING, SYDNEY OPERA FAN IN WINE GLASS

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing upwards. We will call this the North corner.
• Take the East corner and make an accordion fold all the way to the West corner.
• Holding it firmly, gently pull out each of the 4 loose edges at the North point, fanning them out from left to right.
• Roll up the south corner a little to help the fan to keep its shape and place in a water or wine glass.

SERVIETTE/NAPKIN, DRAMATIC FAN

Steps:

• Place your serviette flat before you in a square shape.
• Carefully make accordion pleats from the very bottom of the serviette to the very top. You will have before you a long thin rectangular strip of pleated material.
• Starting at one end of the strip, carefully roll it up until you reach the 2/3 mark of the strip.
• Lay the spiral shape down so that it sits upright and gently fan out the last section that isn't rolled up.
• Holding the rolled up spiral section firmly, reach into the centre of the spiral and pull it the beginning edge and form it into a a small peak in the center.
• Arrange the serviette on a plate for dramatic effect.

STEP BY STEP NAPKIN / SERVIETTE FOLDING

Steps:

• Take your square napkin, lay it totally flat before you, then fold it in half horizontally.
• Fold again, this time vertically so that you have before you a square a quarter the size of your origonal square.
• Only one of the 4 corners will have 4 open or loose edges. Rotate the square before you so that it looks like a diamond with the four open edges pointing to the bottom.
• We will call the points on your diamond shape East, West, North and the open egded bit, South.
• Make a horizontal fold between the East/West points, bringing the open ended South point up to meet, and on top of, the North point.You will now have a little triangle.
• Take the East point of the triangle and fold it in towards the middle. What was the sloping right hand edge of the triangle is now a vertical edge running down the center of the triangle and there is a little flap sticking out at the bottom.
• Take the West point and fold it into the center the same as you did with the previous East edge, the two vertical lines should meet in the middle, and you will have a diamond shape that has two long sides at the top and two short sides (the two little flaps) at the bottom.
• Pick up your diamond shape and fold the two little flap bits at the bottom completely under, so that they only show on the back of the triangle. The front will now look like a steep triangle with a vertical slit down the middle.
• We will call the points of this triangle East, West and North. With the flaps still folded to the back of the tiangle, fold the East and West points backwards until they meet, and gently crease the two folds that form and meet at the North point.
• The slit in the front will have opened and the 4 open points of the napkin will be hidden in layers inside. Pull very gently on them one by one and they will stand up like the sails of a boat. Some people I know call this napkin a boat, some a flower and some the Sydney Opera House.I don't know its' offical name but set onto a plate or into an empty wine glass, this a very elegant addition to a classy table setting.

SERVIETTE/NAPKIN FOLDING, SIMPLE FAN VARIATION 2

Steps:

• Lay your serviette square out flat before you.
• Take the bottom right and left corners and make an accordion fold strips all the way up to the top right and left corners. If you press these with an iron the pleats will be nice and sharp. Leave unironed for a wavy casual look. (but ironed looks neater) You will now have a thin band the width of your accordion fold.
• Hold the serviette firmly just below the half way point of your accordion pleats and let the bottom part serviette become a little loose and less pleated, then still holding it firmly bend the bottom looser part up towards where your fingers are, to semi wrap around the "stem" of the fan and keep it anchored.
• Slip it (folded over bit first) into a small glass.
• Fan out the accordion pleats at the top to make a pleasing balance to the serviette.