Beer Battered Fish Seafood Recipes

THE BEST BEER BATTERED FISH

Steps:

• Season the fish with salt and pepper.
• Mix together the flour, baking powder, and salt in a bowl with a whisk.
• Dredge the fillets well in the flour mix, shaking off any excess. Refrigerate fillets until ready to fry.
• When the oil is hot, add the beer and honey to the flour mixture and stir well. A couple of lumps are preferable, so don't overwork it. Add a couple ice cubes to the batter.
• Dip a couple of fillets into the batter, coating them completely. Allow any excess batter to drain off.
• Gently place them into the 375°F oil and fry for 30 seconds.
• Flip the fillet, exposing the more-cooked bottom. Drizzle a little bit of batter on top. Flip the fillet back over and drizzle a little batter on top again. Don't overdo it, but just add a thin layer of additional batter.
• Fry the fish until deep golden brown, about 2 minutes total for fish that's an inch thick. Serve immediately.

BEER-BATTERED SEAFOOD

Steps:

• Heat oil (1 1/2 inches) in heavy saucepan or deep fryer to 350°F. Lightly coat fish with 3 to 4 tablespoons Bisquick mix.
• Mix remaining ingredients with hand beater until smooth. (If batter is too thick, stir in additional beer, 1 tablespoon at a time, until desired consistency.) Dip fish into batter, letting excess drip into bowl.
• Fry fish about 2 minutes on each side or until golden brown; drain. Serve hot and, if desired, with tartar sauce.

BEER BATTERED FISH

Steps:

• Heat oil in a deep fryer to 365 degrees F (185 degrees C).
• Rinse fish, pat dry, and season with salt and pepper.
• Combine flour, garlic powder, paprika, 2 teaspoons salt, and 2 teaspoons pepper. Stir egg into dry ingredients.
• Gradually mix in one beer until a thin batter is formed.
• You should be able to see the fish through the batter after it has been dipped.
• Dip fish fillets into the batter, then drop one at a time into hot oil.
• Fry fish, turning once, until both sides are golden brown.
• Drain on paper towels, and serve warm.

BEER BATTER FOR FISH, SHRIMP & ONION RINGS

Steps:

• Mix flour, salt, and baking powder in a bowl using a fork.
• Beat beer, egg and oil together in a separate bowl.
• Stir into flour mixture until well blended.
• Batter should be pretty smooth and moderately thick.
• Dip fish, shrimp, or onion slices in coating and deep-fry in hot oil that has been heated to 350 degrees, until it becomes golden.
• Drain, and serve while hot and crispy.
• This recipe also works well with chicken tenders and vegetable pieces; whatever you like to coat with beer batter.