United Nations Beer Can Chicken Recipes

BEER-BRINED BEER-CAN CHICKEN

Steps:

• Make the brine: Combine the beer, brown sugar, salt, orange zest, orange juice and cardamom pods in a bowl; stir until the sugar and salt dissolve.
• Put the chicken in a gallon-size resealable plastic bag and add the brine; seal and refrigerate 2 hours.
• Prepare the grill: For a charcoal grill, pile 3 to 4 pounds briquettes in the grill; ignite and let burn until the coals are ashy. For a gas grill, preheat to high.
• Prepare the chicken: Remove from the brine and pat dry; reserve the orange zest and cardamom. Rub the olive oil all over the skin. Loosen the skin on the breasts and legs with your fingers; rub 1 garlic clove under and over the skin. Combine the brown sugar, coriander, cumin, paprika, allspice, 1 1/2 teaspoons salt and a few grinds of pepper; rub under and over the skin of the chicken and inside the cavity.
• Pour half of the remaining beer can into a disposable 8-inch-square pan. Add the reserved orange zest to the pan. Poke 3 or 4 holes into the top sides of the beer can using a paring knife. Add the remaining 3 smashed garlic cloves and the reserved cardamom pods to the can.
• For a charcoal grill, bank the coals to both sides in two piles; nestle the pan with the beer between the coals and replace the top grill grate. For a gas grill, reduce the heat to medium on one side and turn off the burners on the other; place the pan under the grate on the unlit side.
• Set the chicken over the beer can, inserting the can into the cavity so 1 inch of the can is exposed. Set on the grill grates over the drip pan so the chicken balances on the can and legs like a tripod. Cover the grill and cook until the chicken is golden brown and a thermometer inserted into the thickest part of the thigh registers 165 degrees F. If using charcoal, this will take about 1 hour 20 minutes; add a handful of briquettes to each bank of coals every 30 minutes to maintain the heat. If using gas, it will take about 1 hour 5 minutes; carefully rotate the chicken halfway through.
• Remove the chicken from the grill, discard the can and transfer to a cutting board; let rest 10 minutes before carving.

BEER CAN CHICKEN

Steps:

• Prepare the grill: If you are using charcoal, put the coals on one side of the grill, leaving another side free of coals. If you are using a gas grill, fire up only half of the burners.
• Season the chicken and rub it with oil: Remove neck and giblets from cavity of chicken, if the chicken came with them. Mix the salt, pepper, and thyme in a little bowl, and rub it all over the chicken. Rub the chicken all over with olive oil.
• Lower chicken onto half-filled beer can: Make sure the beer can is open, and only half-filled with beer (drink the other half!) If you want, you can put a sprig of thyme (or another herb like rosemary or sage) in the beer can. Lower the chicken on to the open can, so that the chicken is sitting upright, with the can in its cavity.
• Carefully transfer the chicken to a tray or pan: I say "carefully" because the beer can, and the beer inside of it, is quite hot. One way to do this is to slide a metal spatula under the bottom of the beer can. Use tongs to hold the top of the chicken. Lift the chicken, beer can still inside, and move it to a tray. Let the chicken rest for 10 minutes. Carefully lift the chicken off of the can. If it gets stuck, lay the chicken on its side, and pull out the can with tongs.

BEER CAN CHICKEN

Steps:

• Preheat an outdoor grill for medium-high heat, about 375 degrees F (190 degrees C). Mix the brown sugar, chili powder, paprika, dry mustard, salt, and ground black pepper in a small bowl. Place the half-full can of beer in the center of a plate.
• Rinse chicken under cold running water. Discard giblets and neck from chicken; drain and pat dry. Fit whole chicken over the can of beer with the legs on the bottom; keep upright. Sprinkle 1 teaspoon of the seasoning mix into the top cavity of the chicken. The beer may foam up when the seasonings fall inside the can. Rub the remaining seasoning mix over the entire surface of the chicken.
• Place the chicken, standing on the can, directly on the preheated grill. Close the lid and barbeque the chicken until no longer pink at the bone and the juices run clear, about 1 hour 15 minutes. An instant-read thermometer inserted into the thickest part of the thigh, near the bone should read 180 degrees F (82 degrees C). Remove the chicken from the grill and discard the beer can. Cover the chicken with a doubled sheet of aluminum foil, and allow to rest in a warm area for 10 minutes before slicing.

BEER-CAN CHICKEN

Steps:

• Build a fire in your grill, leaving approximately half the grilling area free of coals. If using a gas grill, turn burners to high and then, when ready to cook, turn off the burner on the side where you will place the chicken. If using an oven, heat to 425 degrees.
• Remove neck and giblets from chicken. Rinse the chicken in cold water. Pat dry.
• Combine all the spices in a large bowl, then apply the dry rub to the chicken, inside and out.
• Put the beer can on a solid surface. Pick up the chicken and, taking a leg in each hand, put the cavity over the can and slide the bird down onto it. Carefully transfer the bird and the can to the cool side of your grill, its back to the fire, balancing the chicken upright and using the legs to support it in this position. If using an oven, place the chicken upright in a roasting pan using the same method and place carefully into the heat.
• Cover the grill and cook for approximately 1 1/4 hours, basting with barbecue sauce twice during the final half-hour if you'd like, until the breast meat registers 165 degrees on an instant-read thermometer or until the legs are loose in their sockets. (If you're using an oven, you can tent the bird with foil after 45 minutes to keep the skin from getting too dark.) De-can and carve.
• Serve with white barbecue sauce and corn bread.