Texas Rib Eye Steaks Recipes

RIB-EYE STEAKS THAT ARE SUPERB

Steps:

• Remove steaks from the refrigerator and let them sit for about 30 minutes to take the chill out of the meat.
• Now, coat both sides generously with coarse black pepper and granulated garlic powder.
• Heat an iron skillet or a heavy bottomed frying pan until very hot on high heat.
• For each steak, sprinkle onto the skillet, 3/4 teaspoon of coarse salt and allow salt to heat up for at least 1 minute.
• Place the steaks on the coarse salt and cook for 3 minutes; DO NOT DISTURB at all, DO NOT LOOK or even move the steaks.
• Turn the steaks over and cook for an additional 3 minutes; again DO NOT DISTURB at all.
• The cooking time of 6 minutes gives you a medium-rare steak; DO NOT OVERCOOK.
• If you desire to cook it to medium, then cook for an additional 30 seconds to 1 minute per side.
• Remove steaks to a plate, cover with foil and let rest for 5 minutes, so that all juices are absorbed by the meat.
• Scrape off any excess coarse pepper and salt if desired and discard.
• I prefer to slice the steaks on an angle about 1/4 inch to 3/8 inch thickness.
• Serve with freshly processed horseradish.
• NOTE; Make sure that the heat is on as HIGH as possible without burning at all times during cooking the steaks. This will vary depending on your cooktop.
• Do not use ordinary table salt.
• Beef Tenderloin steaks are also real great cooked in this manner. If using a steak thicker than 1 inch, add 1 extra minute per side for medium-rare.

RIB-EYE STEAK

Steps:

• Preheat a grill to high heat.
• Place rib-eye steaks on a large platter and season with rub on all sides. Transfer seasoned steaks to the hot grill, and cook for 4 to 6 minutes on each side for medium-rare, longer if desired. Remove steaks and let rest for 5 to 10 minutes before serving.
• In a small bowl, combine all ingredients, to taste. Adjust the ratio of spices to your preference.

TEXAS RIBEYE RECIPE

Steps:

• Heat grill to medium-high heat.
• Mix all ingredients except steaks until blended.
• Grill steaks 4 to 6 min. on each side or until medium doneness (160ºF), brushing frequently with steak sauce mixture.
• Cut steaks in half to serve.

TEXAS RIB-EYE STEAKS

Steps:

• To make the rub: using a spice grinder or mortar and pestle, crush the peppercorns; place in a small bowl and thoroughly mix with the rest of the rub ingredients.
• To make the sauce: in a small saucepan, whisk together all the sauce ingredients with ¼ water; simmer over low heat for about 10 minutes, stirring occasionally, to allow the sugar to fully dissolve and all of the flavors to blend; set aside while you grill the steaks.
• Allow steaks to stand a room temperature for 20-30 minutes before grilling.
• Press the rub into both sides of the steaks; lightly brush or spray both sides of the steaks with the olive oil.
• Grill over direct high heat until the internal temperature reaches 145° for medium rare, 8-10 minutes, turning once halfway through grilling time.
• Remove from the grill and allow to rest for about 5 minutes.
• Serve warm with the sauce on the side.

RIB-EYE STEAK RUB

Steps:

• Combine all ingredients, except oil, in a large bowl. While stirring, add olive till the mixture is a "slushy" consistency. Submerge steaks in mixture, rubbing it into the surface of the steaks. Marinate steaks in mixture for approximately 30 minutes. Preheat grill to 425 to 450 degrees F and place steaks on grill, flipping halfway through. To cook a 16-ounce steak to preferred doneness, cook for: rare, 2 to 3 minutes on each side, medium-rare, 4 to 5 minutes on each side and medium, 6 to 7 minutes on each side