Walnut Lace Cookies Recipes

LACE COOKIES (FLORENTINE COOKIES)

Steps:

• Preheat the oven to 350 degrees F (175 degrees C). Line a baking sheet with a silicone liner (such as Silpat®).
• Place almonds into the bowl of a food processor; alternate pulsing and running at full speed every few seconds until finely chopped and crumblike. Be careful not to go too far; you don't want them too fine and pasty.
• Combine butter, brown sugar, and honey in a saucepan over medium heat. Stir a few times and cook until melted and dissolved. Bring to a boil, then carefully remove from the heat.
• Add vanilla extract, salt, and flour, and whisk until smooth. Add chopped almonds and mix with a spatula until everything is combined.
• Drop eight uniformly sized, rounded spoonfuls of batter (each about 2 teaspoons, or 15 grams) onto the prepared sheet. Fine-tune the cookie shapes and make sure they are evenly spaced.
• Place in the center of the preheated oven and bake until golden brown and a bit darker around the outsides, 10 to 12 minutes, rotating the pan halfway through.
• Remove from the oven and slide the silicone liner off the baking sheet and directly onto the countertop. Allow to sit until cool and crisp, 3 to 5 minutes, then gently peel cookies off the liner. Repeat to bake remaining batches.
• Spread melted chocolate over the flat side of one cookie. Place a second cookie, flat-side down, on top to make a sandwich and press very gently to seal. Repeat to form remaining cookies. Let sit until chocolate has firmed up, about 30 minutes.

WALNUT COOKIES II

Steps:

• Preheat the oven to 375 degrees F (190 degrees C). Grease cookie sheets.
• In a medium bowl, stir together the flour, white sugar, brown sugar, and baking soda. Add the egg, vanilla, and butter; mix until dough forms. Stir in the chopped walnuts. Roll dough into 1 inch balls and place 2 inches apart onto the prepared cookie sheets.
• Bake for 8 to 10 minutes in the preheated oven, until the edges are golden brown. Allow cookies to cool on baking sheet for 5 minutes before removing to a wire rack to cool completely.