Reverse Sear Filet Mignon Or Ribeye Filet Recipes

REVERSE-SEAR RIBEYE STEAK

Steps:

• Season steak on both sides with the salt and place on a rack set inside a rimmed sheet pan. Refrigerate for at least 6 hours, or up to 24.
• Heat oven to 200ºF. Insert a probe thermometer horizontally through the side of the steak and roast, still on the rack and sheet pan, until it reaches an internal temperature of 120ºF, about 1 hour. Remove steak from the oven and rest, uncovered, for 10 minutes.
• Meanwhile, place a 12-inch cast iron skillet over high heat until it reaches at least 600ºF, at least 10 minutes. (If you don't have an infrared thermometer, you'll know you're close when 1/2 teaspoon water dropped in the middle of the pan has completely evaporated in 5 seconds.
• Brush a very light coat of peanut oil onto both sides of the steak. Transfer to the hot skillet and sear on each side until deeply browned, 45 seconds per side. Use a stopwatch!
• Transfer to a clean rack and let rest for 5 minutes. Slice diagonally against the grain to serve.

HOW TO REVERSE SEAR A STEAK

Steps:

• Season the steaks generously with steak seasoning on all sides (top, bottom and edges), using a total of 1/2 tablespoon per 8-oz steak. Gently push and rub the seasoning into the steaks so that it sticks well. Roll the edges in any seasoning that falls off.
• Place an oven-safe wire rack onto a baking sheet. Place steaks on top. Place the rack with the steaks, uncovered, into the refrigerator overnight, or up to 24 hours, to dry out the surface of the steak. (This helps get a great sear later.)
• When you are ready to cook the steak, set the pan out on the counter for 30 minutes to bring it to room temperature.
• Preheat the oven to 200 degrees F (93 degrees C).
• Place the steaks (with baking rack and baking sheet) into the oven. Roast until the steak reaches your desired temperature:* 110 degrees for Rare - about 35-45 minutes* 120 degrees for Medium Rare - about 45-55 minutes* 130 degrees for Medium - about 55-65 minutes* 140 degrees for Medium Well - about 65-75 minutes* 150 degrees for Well Done - about 75-85 minutes(Note: These are NOT final temperatures, just the temperature that the steaks need to reach in the oven! The temperature will rise an additional 10-15 degrees when searing later.)
• Use an instant read thermometer, or even better a probe thermometer, to check the internal temperature starting at 25 minutes and every 5-10 minutes after that, until the intended temperature is reached. Once steaks reach the temperature you want, remove them from the oven immediately and set aside.
• Heat 1 tablespoon (14.8 ml) of oil in a large cast iron skillet over medium-high heat for about 2 minutes, until it's so screaming hot that it just barely starts to smoke.
• Add the steaks to the skillet in a single layer. (If your steaks are large, you can do this in two batches.) Cook for 1-2 minutes, until a browned crust forms on the bottom. If using the optional butter and garlic, add them right before flipping, placing the garlic cloves directly into the butter as it starts to melt. (If cooking steaks in batches, use half the butter and garlic for each of the two batches.) Allow the garlic to sizzle in the butter and use a large spoon to baste the butter over the steak occasionally while finishing off the sear on the other side. (You can tilt the pan to help gather the butter for basting, keeping the garlic in the butter.)
• Flip once and cook for 1-2 minutes again, until browned on the other side. While browning the second side, use tongs to hold the steaks' sides against the pan to sear the edges one at a time (the other steaks will sear on the 2nd side while you sear the sides of one steak).
• If working in batches, remove the finished steaks from the pan and cover to keep warm (or serve right away). Wipe down the pan, and reheat with additional oil. Repeat the searing steps above with the remaining butter and garlic, if using.
• Serve immediately (no need to rest!). Slice against the grain.

REVERSE SEARED RIBEYE

Steps:

• Preheat the oven to 225 degrees F.
• Season all sides of the rib-eyes liberally with salt and pepper. Place on wire rack-lined baking sheet. Bake until the desired internal temperature is reached, 105 degrees F for rare, 115 for medium rare and 125 for medium, 1 1/2 to 2 hours. When the rib-eyes come out of the oven, tent loosely with aluminum foil while preheating the skillet.
• Heat a cast-iron skillet over medium-high heat. Add the oil, then sear the steaks on the first side for about a minute. Flip the steaks and add the butter to the skillet. Once the butter has melted, continue to cook the steaks, continuously basting with the melted butter, until seared on the second side, about 45 seconds. Sear the fat cap as well to crisp up, 30 seconds to 1 minute.
• Slice and serve immediately, spooning the pan juices over each slice. There is no need to rest the meat with the reverse sear method.

REVERSE-SEAR STEAK RECIPE BY TASTY

Steps:

• Preheat oven to 200°F/95°C.
• Pat the steak dry with a paper towel, and generously season all sides of the steak with salt and pepper.
• Transfer to a wire rack on top of a baking sheet, and bake for about 45 minutes to an hour, until the internal temperature reads about 125°F/50˚C for medium-rare. Adjust the bake time if you like your steak more rare or well-done.
• Heat the canola oil in a pan over high heat until smoking. Do not use olive oil, as its smoke point is significantly lower than that of canola oil and will smoke before reaching the desired cooking temperature.
• Sear the steak for 1 minute on one side, then flip.
• Add the butter, garlic, rosemary, and thyme, and swirl around the pan. Transfer the garlic and herbs on top of the steak and baste the steak with the butter using a large spoon.
• Baste for about 1 minute, then flip the steak with tongs and baste the other side for about 15 seconds.
• Turn the steak on its side and cook to render off any excess fat.
• Enjoy!

THE BEST REVERSE-SEAR METHOD FOR THICK STEAKS

Steps:

• Remove steaks from the refrigerator at least 30 minutes before cooking to bring them to room temperature.
• Position racks in the middle and lower third of the oven. Place a cast iron skillet on the bottom rack. Preheat the oven to 225 degrees F (110 degrees C). Line a baking sheet with aluminum foil and place a wire rack on top.
• Pat the steaks dry with a paper towel and season generously on all sides with salt and pepper. Place on the wire rack on the baking sheet.
• Bake in the preheated oven for 40 minutes. Continue baking, checking internal temperature every 10 minutes, until steaks reach 120 degrees F (49 degrees C) for medium-rare. Remove from the oven and set aside.
• Use an oven mitt to remove the hot cast iron skillet from the oven. Set it over medium-high heat on the stovetop. Add oil; heat until it barely starts smoking. Carefully add the steaks, releasing them away from you so the oil doesn't splatter in your direction. Cook until a golden crust forms, turning only once, 2 minutes per side. Use tongs to stand steaks on their sides to render any fat.
• Reduce heat to low and add butter, rosemary, and garlic. Baste steaks with the butter mixture using a spoon, about 3 minutes. Move steaks onto a cutting board and let rest for about 10 minutes.
• Serve steaks whole or sliced, finished with sea salt flakes.

REVERSE-SEAR STEAK

Steps:

• To get an extra-crispy crust, place the steak on a wire rack set over a baking sheet and leave, uncovered, in the refrigerator overnight. The air in the refrigerator is dry and will help dry the outside of the steak.
• When ready to cook, preheat the oven to 250 degrees F.
• Generously season the steak all over on both sides with salt, pepper, garlic powder and mushroom powder if using.
• Place the steak, still on the wire rack and baking sheet, directly into the oven. Cook, checking the internal temperature occasionally, for 20 to 40 minutes. Ideally you want the steak to be 120 degrees F for medium-rare/medium, which is my favorite.
• Just before the steak comes out of the oven, heat a dry cast-iron skillet over high heat for 1 minute. Add the butter, then immediately add the steak to skillet and cook until each side is crusty and well browned, about 45 seconds per side, pushing down to sear. Using tongs, hold the steak sideways to sear the edges. Serve right away; there's no need to let reverse-seared steaks rest.