Double Chocolate Salted Peanut Bark Recipes

EASY CHOCOLATE BARK

Steps:

• If you have time, toast the nuts/seeds: Preheat the oven to 350 degrees Fahrenheit. Toast the nuts/seeds on a rimmed baking sheet until fragrant and turning lightly golden on the edges, about 6 to 9 minutes. Transfer the nuts to a cutting board and roughly chop them.
• In the meantime, melt the chocolate in a microwave-safe bowl in 30-second increments, stirring after each one. Don't overdo it. The chocolate is done when it's about 90% melted-keep stirring off the heat and the pieces should completely dissolve. (Alternately, you can use melt it in a heat-proof bowl set over a saucepan of gently simmering water.)
• Cover a large, rimmed baking sheet with parchment paper. Use a silicone or rubber spatula to spread chocolate evenly over the center area of the baking sheet-aim for about 1/4″ thickness (it won't reach the edges).
• Sprinkle the nuts evenly over the chocolate, followed by the dried fruit. If you're adding flaky salt, crush it between your fingers as you sprinkle it over the chocolate. Lightly use your palms to press the toppings into the chocolate.
• If you're in a hurry, place the pan on a flat surface in the refrigerator to harden for about 15 minutes. If you're not, let the chocolate cool at room temperature for 2 to 4 hours, until completely hardened.
• Once the chocolate is completely hardened, use your hands to break it into about 25 pieces. Serve immediately, or cover and store at room temperature for up to 1 week.

VALENTINE'S DOUBLE CHOCOLATE BARK

Steps:

• Bring a small pan with 1 inch of water to a boil over medium-low heat. Place the white chocolate in a small bowl and place over the simmering water. When it is almost halfway melted, remove the bowl from the heat to a towel. Continue to stir with a rubber spatula until completely melted. Set aside. Repeat with the bittersweet chocolate.
• Pour the bittersweet chocolate onto a parchment-lined rimmed baking sheet and spread to 1/4-inch thick. Use a rubber spatula to drizzle the white chocolate over the bittersweet in zigzags and decorative patterns. Run the tip of a skewer through the chocolate in different directions to make swirls. Sprinkle with the toppings as desired. Refrigerate for about 30 minutes, then break into pieces.

CHOCOLATE PEANUT BARK

Steps:

• Line a 15x10x1-in. pan with parchment; set aside. , In a double boiler or metal bowl over hot water, melt chocolate until 2/3 are melted. Remove from heat; stir until smooth. Stir in 1/4 cup each Reese's pieces, peanut butter cups and peanuts. Spread into prepared pan; top with remaining ingredients, pressing lightly to adhere (pan will not be full). Refrigerate until firm, 15-20 minutes. Break or cut into pieces. Store in an airtight container.

PEANUT ROCKY ROAD BARK

Steps:

• Using a pencil, draw an 8 x 11-inch rectangle on a piece of parchment paper. Turn the parchment paper over so the pencil mark doesn't get onto the chocolate and place it on a sheet pan.
• Place three-quarters of the bittersweet chocolate in a heatproof glass bowl and put it in the microwave on high for 30 seconds. (Time it carefully.) Stir the chocolate with a rubber spatula, return it to the microwave for another 30 seconds, then stir again. Continue to heat and stir in 30-second intervals until the chocolate is just melted. Immediately stir in the remaining bittersweet chocolate and allow it to sit at room temperature, stirring often, until it's completely smooth. (If you need to heat it a little more, place it in the microwave for another 15 seconds.)
• Pour the melted chocolate onto the parchment paper and spread it lightly to fill the drawn rectangle. Sprinkle the top evenly with the peanuts, chocolate chips and marshmallows. Press them lightly so they will set in the chocolate.
• Place the white chocolate in a small, heatproof glass bowl and microwave it for 30 seconds. Stir with a rubber spatula and return to the microwave for 15 seconds, then stir again. Continue to heat and stir in 15-second intervals until the chocolate is just melted.
• Using a spoon, drizzle the white chocolate onto the bark in straight lines.
• Set aside for at least 3 hours until very firm. Cut or break the bark in 16 pieces and serve at room temperature.

DOUBLE CHOCOLATE PEANUT BUTTER BARK

Steps:

• Butter 15x10-inch jelly roll pan. Line with waxed paper or parchment. Melt 1 pound white chocolate with peanut butter in large bowl set over saucepan of simmering water, stirring occasionally until chocolate is melted and smooth.
• Meanwhile, melt bittersweet chocolate in medium bowl set over saucepan of simmering water, stirring occasionally. Melt remaining 2 ounces white chocolate in small bowl set over saucepan of simmering water, stirring constantly.
• Remove all bowls from over water. Pour peanut butter mixture onto prepared pan, spreading to cover surface completely. Using spoon, drizzle melted bittersweet chocolate in lines over peanut butter mixture. Draw tip of small sharp knife through chocolate-drizzled mixture to marbleize. Using spoon, drizzle melted white chocolate over. Draw tip of knife through chocolates to marbleize. Chill until firm, at least 2 hours or over-night. Cut into 2-inch triangles or other shapes. Cover and chill. (Can be made 2 weeks ahead. Keep chilled.) Serve cold.