Dianes Mexican Red Chile Sauce Recipes

MEXICAN RED CHILE SAUCE

Steps:

• Cut the chiles open and remove stem and seeds: Working on one chile at a time, use a paring knife to cut a slit all the way down one side of a chile. Open up the chile and remove the stem and seeds. Remove as much of the veins as you can. Reserve a few of the seeds or veins for adding later if you want added heat. Note when working with chiles, either wear protective gloves or wash your hands very thoroughly with soap and warm water after handling the chilies. Do not touch or rub your eyes if you have been handling chili peppers.
• Heat the chiles on a skillet: Heat a large skillet on medium heat. Flatten out the dried chiles as well as you can and place on the skillet to heat. Press down on the opened chiles and leave for a few seconds. Turn the chiles over and heat a few seconds more. You do not want to toast or burn the chiles! If they burn, they'll turn bitter. Just heat them enough to draw out more of their flavor.
• Soften the chiles in hot water: Add the chiles to a small saucepan and add enough water so that they are just covered. Bring to a boil. Remove from heat and let sit for 10 minutes, until the chiles have softened and plumped up. (OR place the chiles in a small saucepan and pour boiling water over them to cover. Let sit for 15 minutes, until softened.)
• Purée with garlic, seasonings, water or poaching liquid: Remove the chiles from the pan, reserve the soaking water, and place the chiles in a blender. Add the garlic, salt, crushed peppercorns, ground cloves, and 1 1/2 cups of the soaking liquid (taste the soaking water first, if it seems bitter, use plain water instead). Purée for 2 minutes, until the sauce is completely smooth. Taste the sauce and adjust the seasoning. If you want more heat, add in a few of the seeds or veins and purée some more. Add more salt if needed.
• Strain through sieve into a skillet, simmer: Pour the sauce through a sieve into a skillet. Add a tablespoon of olive oil to the sauce. Bring to a simmer and reduce heat to maintain the simmer, cook for 10 minutes. Skim off the foam. Remove from heat. Use immediately or pour into a glass jar (plastic will get stained) and refrigerate.

AUTHENTIC ENCHILADA SAUCE

Steps:

• Start with that all important step: Roasting! Heat a heavy non-stick skillet (I like to use cast iron) over medium-high heat. Don't add any oil. Lay the dried peppers on the skillet and toast them for a minute or two on each, just until they become very fragrant. It's better to under-toast than to over-toast them as they will become very bitter if scorched. Remove and set aside. Next place the onion, garlic and tomatoes on the skillet and toast until lightly browned.
• Remove the stems from the peppers (using gloves if you're using hot peppers), slice the peppers open and remove and discard all of the seeds and the membranes (contrary to popular belief, it's the membranes not the seeds that are hot, the seeds are bitter). Place the peppers in a bowl.Pour the boiling water over the peppers, cover the bowl and let them sit for 20-30 minutes until soft.
• Place the peppers and their liquid along with the onion, tomato, garlic and all remaining ingredients (except for the chocolate if using) in a blender and blend until completely smooth.Note: At this point determine for yourself whether your sauce needs to be strained. I use a Vitamix blender which does an excellent job of blending the sauce to a very smooth puree, so I don't bother straining it.
• Time to cook the sauce: Heat a tablespoon or so of oil to a pot then add red sauce. Simmer it uncovered for about 30 minutes. Add a little more water if you prefer it thinner. The sauce should be the thickness of heavy cream.Optional: For an added flavor touch, add a small piece of semi-sweet chocolate at the end and stir until melted.If the sauce is very bitter, add a touch of brown sugar. SEE NOTE.
• Store in the fridge for up to 2 weeks or freeze it for several months. I like to freeze about a cup of it per freezer bag so I can conveniently grab a bag as needed.Makes approx. 5-6 cups.

DIANE'S MEXICAN RED CHILE SAUCE

Steps:

• Place chiles on a baking sheet. Toast lightly in a 400° oven for 3 or 4 minutes only or until they give off a mild aroma. If burned, chiles will become very bitter.
• Remove from the oven, let cool to touch, then remove and discard stems, seeds and any pink pithy materials inside the chiles. Rinse in cool water, drain briefly, then cover chiles with hot water, let stand one hour.
• Place chiles in a blender with enough of the water to blend; whirl until smooth, (or scrape pulp from the skin with a table knife, then, put through a wire strainer). Add remaining water, tomato sauce, garlic, oil, salt, oregano, and cumin. Simmer, uncovered, for 10 minutes, stirring occasionally, to blend the flavors. Chill up to 1 week, or freeze for longer storage.

NEW MEXICO RED CHILE SAUCE

Steps:

• Coat the bottom of a heavy saucepan with oil; add chile pods. Toast over medium heat until aromatic, about 3 minutes.
• Stir in onion and garlic; cook and stir until fragrant, about 5 minutes. Add enough chicken stock to allow pods to float; simmer until they develop the texture of wet leather, 5 to 7 minutes.
• Fill blender halfway with chile-stock mixture. Cover and hold lid down with a potholder; pulse a few times before leaving on to blend. Pour into a bowl; repeat with remaining mixture. Strain sauce through a fine mesh strainer into a saucepan over medium heat. Discard solids.
• Stir cumin, coriander, and oregano into the saucepan; add honey. Cook until sauce is thick and evenly coats the back of a spoon, about 10 minutes.

RELAJO (SALVADOREAN RED CHILE SAUCE)

Steps:

• Place the chile ingredients in a medium size pot and cover with water. Bring the chiles and tomatoes to a boil, cover and continue boiling for 20 minutes.
• Next, place the spice mix ingredients in a saute pan and toast on medium high heat stirring constantly. Make sure to keep everything moving so that the sesame seeds do not burn. Keep toasting the mixture for about 3 minutes until the sesame seeds turn golden brown. Remove the mixture from the heat and set aside to cool.
• Once the chiles and tomatoes are cooked, remove from the heat and allow them to cool for about 15 minutes.
• Working in two batches, place the chile ingredients in the blender with a half cup of the cooking liquid for each batch. Blend on high for 2 minutes.
• Pour the blended chile into a large pan and set aside.
• Next, pour the spice mix ingredients in the blender, with 1 cup of water. Blend on high for 5-8 minutes until the sesame seeds are completely blended and the liquid is smooth (may feel a little gritty but will not be chunky at all).
• Next, pour the spice mix into the chile mix and bring the pot to a low boil over medium heat. Once the chile has boiled for 5 minutes add the margarine stirring to incorporate. Once the margarine is melted add the chicken and beef consomme powder and stir to incorporate.
• Continue cooking the chile sauce on medium heat for an additional 10 minutes.
• Note: The sauce prepared above would be for Salvadorean Tamales. Add an additional cup of water, 1/2 tsp of Worcestershire sauce and 1/4 tsp of celery salt when you add the consomme for the sauce that is served over Panes Rellenos. For Sopa de Pata, use the same ingredients for the Panes Rellenos but add another 6 cups of water and double the chile and spice mix recipe.

MEXICAN RED CHILE SAUCE

Steps:

• Preheat oven to 400 degrees F.
• Place chiles on a baking sheet. Toast lightly in oven, 3 or 4 minutes, until they give off a mild aroma. Do not burn, otherwise, chiles will be very bitter.
• Remove chiles from oven and set aside until cool enough to handle.
• Remove and discard stems, seeds, and any pink pithy materials.
• Rinse chiles in cool water, drain briefly, then cover with hot water and soak for an hour.
• Process chiles in blender with enough of the soaking water to obtain a nice, blended consistency.
• Add remaining water, tomato sauce, garlic, oil, salt, oregano, and cumin. Simmer, uncovered, for 10 minutes, stirring occasionally.
• Sauce can be refrigerated for up to 1 week or frozen for later use.

MEXICAN RED SAUCE

Steps:

• Working on one chile at a time, use a kitchen shears to cut a slit all the way down one side of a chile. Open up the chile and remove the stem and seeds. Remove as much of the veins as you can. Reserve a few of the seeds or veins for adding later if you want added heat.
• Heat a large skillet on medium heat. Flatten out the dried chilies as well as you can and place on the skillet to heat. Press down on the opened chilies with a metal spatula for a few seconds. You may hear some sizzle or popping. You do not want to toast or burn the chilies, just heat them enough to draw out more of the flavor.
• Add the chilies to a small saucepan and add enough water so that they are just covered. Bring to a boil. Remove from heat and let sit for 10 minutes, until the chilies have softened and plumped up. (OR pour place the chilies in a small saucepan and pour boiling water over them to cover. Let sit for 15 minutes, until softened.).
• Reserving the soaking water, remove the chilies from the pan and place in a blender. Add the garlic, salt, ground pepper, ground cloves, and 1 1/2 cups of the soaking liquid (taste the soaking water first, if it seems bitter, use water or even broth instead). Purée for 2 minutes, until the sauce is completely smooth. Taste the sauce and adjust the seasoning. If you want more heat, add in a few of the seeds or veins and purée some more. Add more salt if needed.
• Pour the sauce through a sieve into a skillet. Add a tablespoon of olive oil to the sauce. Bring to a simmer and reduce heat to maintain the simmer, cook for 10 minutes. Skim off the foam. Remove from heat. Use immediately or pour into a glass jar (plastic will get stained) and refrigerate.