Pie Crust Tender Butter Recipes

BUTTER PIE CRUST

Steps:

• Pulse the butter, flour, and salt in a food processor until the mixture resembles coarse sand, with some small lumps of butter (no larger than pea-sized) remaining. This will probably take 15 to 20 (1-second) pulses.
• Feed one tablespoon of ice water at a time through the feed tube of the food processor, pulsing 4 to 5 times after each addition. Stop adding water when the mixture begins to form large clumps and pulls away from sides of the food processor bowl.
• Dump the mixture onto a work surface and push it together into a big lump using your hands. Evenly divide the dough in half. Quickly form the halves into two balls and flatten them into 4-inch disks. Place each disk in a plastic baggie or wrap it in plastic wrap, and refrigerate for at least an hour and up to 4 days. Remove the dough from the refrigerator 3 to 4 minutes ahead of time so that it just starts to soften and is easier to roll.
• Lightly flour your work surface and rolling pin. Roll out the disk of dough from the center moving outward, turning it a quarter turn and repeating until the diameter of the whole crust is about 4 inches larger than the pie pan. If the edges of the crust start to split, pinch them together before continuing. Once the crust is rolled out, allow it to rest for 5 minutes.
• Carefully transfer the pie crust to the pie pan, flute the edges, and proceed with your pie recipe as directed. (To prebake your crust, see 'Notes' section below for directions. Further details can also be found in the post above the recipe card.)

OUR FAVORITE PIE CRUST RECIPE-HOW TO MAKE A TENDER PIE CRUST

Steps:

• For a flaky, tender crust (as opposed to one that's harder, mealy, and more cookie-like), the following works well.
• Whisk together all of the dry ingredients, reserving a few tablespoons of the flour.
• Cut in half of the fat, working the mixture until it's mealy and crumbly.
• Place the reserved flour on your work surface, and coat the remaining fat with the flour.
• Use a rolling pin or the heel of your hand to flatten the fat till it's about 1/2-inch thick.
• Break this flour-coated fat into 1-inch pieces, and mix it into the dough, just till it's evenly distributed; some of the pieces of flour-coated fat should break into smaller pieces.
• Sprinkle the liquid(s) over the dough while tossing with a fork.
• Just as soon as the dough becomes cohesive (i.e., you can squeeze it into a ball easily), stop mixing; there should still be visible pieces of fat in the dough.
• Flatten the dough into a disk and wrap it in plastic wrap or waxed paper.
• Refrigerate for 30 minutes or longer; this resting period allows the flour to absorb the water, making the dough easier to roll out.
• Flour your work surface and roll the dough into a 12 x 9-inch (approximately) rectangle.
• (If it isn't holding together well, sprinkle it lightly with a couple of teaspoons of water.
• Fold the dough into thirds (like a letter), then fold it into thirds the opposite way, to form a rough square. Wrap it well and refrigerate again.).
• When you're "ready to roll," remove the dough from the fridge.
• If the dough is made with all lard and/or vegetable shortening, you'll be able to work with it directly from the refrigerator.
• A dough made with all butter will need to warm slightly (10 to 15 minutes) before rolling, as butter becomes brittle when it's refrigerated.
• Dough made with a combination of butter and shortening should rest for about 5 minutes at room temperature before rolling.
• Roll the dough to the size needed (about 13 inches for a 9-inch pie).
• Fill and bake as directed in your recipe.
• Note: in this particular recipe, cut all of the lard or vegetable shortening into the flour, then coat the butter with flour before adding it to the dough.

BUTTER FLAKY PIE CRUST

Steps:

• In a large bowl, combine flour and salt. Cut in butter until mixture resembles coarse crumbs. Stir in water, a tablespoon at a time, until mixture forms a ball. Wrap in plastic and refrigerate for 4 hours or overnight.
• Roll dough out to fit a 9 inch pie plate. Place crust in pie plate. Press the dough evenly into the bottom and sides of the pie plate.

CLASSIC BUTTER PIE PASTRY

Steps:

• Combine flour and salt; cut in butter until crumbly. Gradually add ice water, tossing with a fork until dough holds together when pressed., Shape dough into a disk for a single-crust pie; for a double-crust pie, divide dough in 2 with 1 piece slightly larger than the other. Shape into 2 disks. Wrap and refrigerate 1 hour or overnight., On a lightly floured surface, roll 1 disk of dough to a 1/8-in.-thick circle; transfer to a 9-in. pie plate. , For a single-crust pie: Trim crust to 1/2 in. beyond rim of plate; flute edge. Fill or bake according to recipe directions., For a double-crust pie: Add filling to pie. Roll remaining dough to a 1/8-in.-thick circle. Place over filling. Trim, seal and flute edge. Cut slits in top. Bake according to recipe directions.

TENDER PIE CRUST

Steps:

• Blend flour, sugar, and salt in processor. Add butter; using on/off turns, process until coarse meal forms. Add 8 tablespoons ice water and cider vinegar; blend until moist clumps form, adding more ice water by teaspoonfuls if dough is dry. Gather dough together. Turn dough out onto work surface; divide dough in half. Form each half into ball and flatten into disk. Wrap disks separately in plastic; refrigerate at least 1 hour. (Can be made ahead. Keep dough refrigerated up to 2 days, or enclose in resealable plastic bag and freeze up to 1 month, then thaw in refrigerator overnight. Soften slightly at room temperature before rolling out.)