Peppermint Bark Trifle Recipes

TRIPLE-CHOCOLATE PEPPERMINT TRIFLE

Steps:

• Preheat oven to 350 degrees. Make the cake: Coat a 9-inch round cake pan with cooking spray. Line bottom with parchment paper; coat with cooking spray.
• Bring milk and butter almost to a boil in a small saucepan. Remove from heat, and set aside. Whisk flour, cocoa, baking powder, and salt in a bowl. Put eggs into the bowl of an electric mixer fitted with the whisk attachment. Beat on high speed until pale and fluffy. Gradually add sugar, beating until pale and thick, about 5 minutes. Add vanilla. Reduce speed to low. Add hot milk mixture in a slow, steady stream. Add flour mixture, and beat until just combined.
• Pour batter into pan. Bake until center springs back when lightly touched, 25 to 30 minutes. Let cool in pan on a wire rack 20 minutes. Turn out onto rack. Remove parchment; let cool completely. Halve cake horizontally.
• Make the syrup: Bring sugar and 1/4 cup water to a boil in a small saucepan, stirring until sugar has dissolved. Let cool completely. Stir in liqueur.
• Make the mousse: Prepare an ice-water bath; set aside. Bring 1 cup cream just to a boil in a small saucepan. Place white chocolate in a food processor; with machine running, pour in hot cream in a slow, steady stream, and process until smooth. Transfer to a medium bowl set in ice-water bath. Let cool, stirring occasionally, until thick enough to hold ribbons on surface, about 15 minutes.
• Beat remaining 1 1/2 cups cream to nearly stiff peaks. Fold into chocolate mixture, then fold in candies. Cover with plastic wrap, and refrigerate until thickened and almost firm, 4 to 6 hours.
• Make the pudding: Put chocolate into a large bowl; set aside. Bring cream almost to a boil in a small saucepan. Whisk yolks in a bowl. Pour in hot cream in a slow, steady stream, whisking.
• Pour mixture back into pan. Cook over medium heat, stirring, until thick enough to coat the back of a spoon, about 1 minute. Pour through a fine sieve over chocolate; whisk until smooth. Set bowl in ice-water bath. Let cool, stirring occasionally, until thick enough to hold ribbons on surface, about 15 minutes. Place plastic wrap directly on surface; refrigerate until set, about 3 hours.
• To assemble: Spread one-third of the mousse into bottom of a glass trifle bowl that is 8 to 10 inches in diameter. Top with a cake layer, and brush with half the syrup.Top with half the pudding, then another third of mousse. Place remaining cake layer on top; brush with remaining syrup. Top with remaining pudding, then mousse. Cover with plastic wrap, and refrigerate 12 hours.
• Beat cream and sugar until soft peaks form. Top trifle with the whipped cream, and sprinkle with candies.

ALMOST-FAMOUS PEPPERMINT BARK

Steps:

• Line a 9-by-13-inch baking dish with aluminum foil, shiny-side up; smooth out any wrinkles. Heat 1 inch of water in a saucepan over low heat until steaming.
• Put all but 3/4 cup of the semisweet chocolate in a heatproof bowl. Set the bowl over the saucepan of steaming water (do not let the bowl touch the water) and stir until one-third of the chocolate is melted. Remove the bowl from the saucepan; keep the steaming water over low heat. Gradually stir the reserved 3/4 cup semisweet chocolate into the bowl, a few pieces at a time, until all of the chocolate is melted. Return the bowl to the saucepan, 5 to 10 seconds at a time, to help melt the chocolate, if needed. Do not rush this step: It may take up to 10 minutes to melt the chocolate.
• Wipe off any moisture from the bottom of the bowl. Stir 3/4 teaspoon peppermint extract into the chocolate, then quickly pour into the prepared baking dish and spread in an even layer. Firmly tap the dish against the counter to remove any air bubbles. Set aside at room temperature until almost set, about 10 minutes.
• Meanwhile, put all but 1 cup of the white chocolate in a large heatproof bowl and repeat the melting process over the steaming water; dry off the bottom of the bowl. Stir in the remaining 3/4 teaspoon peppermint extract; pour over the semisweet chocolate and spread in an even layer. Sprinkle immediately with the crushed candy canes, gently pressing them into the white chocolate. Set aside at room temperature until firm, about 1 hour. Lift the bark out of the pan using the foil and break it into pieces. Store in an airtight container at room temperature for up to 2 weeks.

TRIPLE CHOCOLATE PEPPERMINT BARK

Steps:

• With a pencil and ruler, measure out and mark a 9 by 13-inch (23 by 33 cm) rectangle on a piece of parchment paper large enough to fit in a sheet pan. Flip the paper over (so the pencil marks are on the bottom), and then place the paper on a sheet pan.
• Place the bittersweet chocolate in a heatproof bowl and set it over a saucepan of barely simmering water (do not allow the bottom of the bowl to touch the water). Stir occasionally until the chocolate is melted and smooth. Remove the chocolate from the heat and pour it onto the rectangle on the parchment. Using an offset spatula, spread the chocolate to fill in the rectangle. Chill until set, about 15 minutes.
• While the chocolate is setting, in the same bowl you used to melt the bittersweet chocolate, combine the semisweet chocolate, cream, and peppermint extract. Warm it over the barely simmering water, stirring frequently, until the mixture is just melted and smooth. Remove the bowl from the heat and let the mixture cool until it is room temperature, about 15 minutes. Remove the sheet pan from the refrigerator and pour the semisweet chocolate mixture over the chilled chocolate rectangle. Using an offset spatula, spread the semisweet chocolate in an even layer, then chill until very cold and firm, about 1 hour.
• In a clean bowl, warm the white chocolate over barely simmering water until the chocolate is smooth. Working quickly, pour the white chocolate over the firm semisweet layer, using a clean offset spatula to spread it to cover. Sprinkle with the crushed candy canes. Chill in the refrigerator just until firm, about 20 minutes.
• Carefully transfer the parchment paper from the sheet pan to a large cutting board. Trim away any uneven edges of the bark so the sides are straight. Cut the bark into 2 by 9-inch (5 by 23 cm) wide strips, then cut the strips into squares or triangles.
• Let the bark stand at room temperature for 10 minutes before serving. Store in an airtight container, layering sheets of wax paper or parchment paper between the layers so the pieces don't stick to one another, in the refrigerator for up to 1 week.

DARK CHOCOLATE PEPPERMINT BARK

Steps:

• Line a 15x10x1-in. pan with parchment; set aside. , In a double boiler or metal bowl over hot water, melt baking chips until 2/3 are melted. Remove from heat; stir in peppermint oil until smooth. Spread into prepared pan. Melt dark chocolate chips in another bowl. Drizzle over top of white layer; cut through mixtures with a knife to swirl. Sprinkle with peppermint candies (pan will not be full). Refrigerate until firm, 15-20 minutes. Break or cut into pieces. Store in an airtight container.

PEPPERMINT BARK

Steps:

• Spread 1/3 of the peppermint candy over a 9x13-inch baking pan lined with wax paper.
• Melt the milk chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching, just until melted. Pour the melted chocolate over peppermint candy in the prepared pan. Sprinkle another 1/3 of the candy on top of the milk chocolate. Refrigerate until the chocolate hardens, about 30 minutes.
• Melt the white chocolate in the top of a double boiler over just-barely simmering water, stirring frequently and scraping down the sides with a rubber spatula to avoid scorching. Stir in the oil-based peppermint flavoring. Pour the white chocolate over the milk chocolate, then spread the remaining 1/3 peppermint candy on top.
• Refrigerate until the white chocolate hardens, about 30 minutes. Cut or break into pieces to serve.