Hollys Texas Brisket Recipes

BRISKET HOTDISH

Steps:

• Season the brisket on all sides with salt and pepper.
• In a large oven-safe braiser, heat the oil over medium-high heat. Add the brisket and cook, turning occasionally, until browned, about 10 minutes. Reduce the heat to medium. Add the leeks, carrots, and celery. Season with salt. Cook, stirring often, until softened, about 10 minutes. Add the garlic and stir until fragrant, about 1 minute. Add the tomato paste and stir to toast, 1 minute. Add the wine to deglaze and use a wooden spoon to scrape any brown bits from the bottom of the pan. Bring the wine to a boil and cook for 3 to 5 minutes. Add 2 1/2 cups of stock, the tomatoes and rosemary. Bring back to a boil, then reduce the heat to medium-low. Simmer, covered, stirring occasionally, until the beef is tender, about 2 hours.
• Place an oven rack in the middle position. Preheat the oven to 400 degrees F.
• Remove the lid from the brisket and continue to cook until the sauce is reduced and thickened to a stew-like gravy, 20 to 30 minutes. Turn off the heat. Using two forks, break up the meat into smaller chunks, but not shredded. Add the peas and stir to combine. Arrange the potato smiles on top in concentric circles.
• Bake until golden, steamy and bubbling, 45 to 50 minutes. Let cool slightly. Garnish with the parsley and chives. Serve with ketchup, if desired.

HOLLY'S TEXAS BRISKET

Steps:

• Preheat grill for medium-low heat or 270 degrees F (132 degrees C), and lightly oil the grate.
• Whisk chili powder, brown sugar, salt, garlic powder, onion powder, ground black pepper, and dry mustard together in a small bowl to create the dry rub.
• Pierce fatty side of the brisket with a knife about 50 times. Sprinkle 1/2 the dry rub generously over the lean side of the brisket. Turn meat over and sprinkle remaining 1/2 the dry rub over the fatty side, rubbing into the pierced fat.
• Cook brisket, uncovered and fatty-side up, on the preheated grill for 4 hours. Transfer brisket to a roasting pan and cover pan tightly with aluminum foil.
• Preheat oven to 270 degrees F (132 degrees C).
• Cook in the preheated oven until meat is tender and pulls easily away from the side of the brisket, about 8 more hours. Let meat rest 30 minutes before slicing.

TEXAS HILL COUNTRY-STYLE SMOKED BRISKET

Steps:

• Using a sharp knife, trim the brisket: Set the brisket flat side down, so the leaner side is underneath and the rounded, fatty point side is on top. Wherever you find a thick sheath of fat on the top surface, trim it to within 1/4 inch of the meat. Now look at the side of the brisket: There's a large pocket of fat between the point and the flat. Using the point of the knife, cut some of it out, but avoid cutting directly into the meat. Turn the brisket so the flat faces up. There's a lump of fat on one side: Again, trim it to within 1/4 inch of the meat. Be careful not to overtrim. It's better to err on the side of too much fat than too little. While you're at it, trim off any thin, sharp corners of the flat part of the meat, so the brisket is slightly rounded.
• Season the brisket: Place the brisket on a rimmed sheet pan and generously season the top, bottom and sides with salt, pepper and, if you like your brisket spicy, red-pepper flakes.
• Create a platform for cooking the brisket by cutting a flat piece of cardboard the size and shape of the brisket. (There's no need to make it any larger; the brisket will shrink considerably during cooking.) Wrap the cardboard template in 2 layers of heavy-duty aluminum foil. Using an ice pick, a metal skewer or other sharp implement, poke holes in the foil-covered cardboard at 1-inch intervals. The idea is to create a perforated platform for the brisket. Set the brisket flat on the foil-covered cardboard, lean side down. (This prevents the lean bottom of the brisket flat from drying out and burning, while the holes still let in the smoke.)
• Light your grill, smoker or cooker (such as a Big Green Egg) and heat it to 250 degrees. If using a kettle grill, start with less charcoal than you would for grilling a steak: A third to a half chimney starter will do it. If using a smoker, place a large heat-proof bowl of water in the smoke chamber. (This is optional, but it creates a humid environment that will keep your brisket moist and help the smoke adhere to the meat.) Add wood as specified by the manufacturer to generate smoke. If using a kamado-style cooker, set up a top-down burn: Load the fire box with lump charcoal, interspersing it with wood chunks or chips. Light 3 or 4 coals on top in the center; gradually, they'll burn down, igniting the coals and wood beneath them.)
• Transfer the brisket on the foil-lined cardboard to the smoker. If using an offset smoker, position the thicker end toward the firebox. Cook the brisket until the outside is dark and the internal temperature registers about 165 degrees on an instant-read thermometer. This normally takes 6 to 8 hours. Refuel your cooker as needed, adding wood to obtain a steady stream of smoke. If the outside of the brisket darkens too much, loosely lay a sheet of foil on top. (Don't bunch it, or the meat will steam rather than smoke, resulting in a pot roast-like consistency.)
• Wrap the brisket: Lay 2 overlapping sheets of pink (unlined) butcher paper or parchment paper on your work surface. Each piece should be about 3 feet long. You want to create a square about 3 feet on each side. Wearing heatproof rubber or silicone gloves (or carefully using tongs), transfer the brisket to the center of this paper square. Fold the bottom section over the brisket. Fold in the sides and roll the brisket over so it's completely swaddled in paper. (It's a little like making a burrito.) Note the orientation: You want the fatty point of the brisket to remain on top. Carefully set the wrapped brisket back on the foil-lined cardboard and return it to the cooker.
• Continue cooking the brisket to an internal temperature of 200 to 205 degrees (it will be deeply browned and very tender), another 2 to 4 hours, bringing your total cooking time to 8 to 12 hours, depending on your cooker and the size of your brisket. (Start monitoring the internal temperature at the 8-hour mark.) Additional tests for doneness include the jiggle test: Grab the brisket with a gloved hand and shake it; the meat will jiggle like Jell-O. You could also try the bend test: Lift both ends and it will bend easily in the middle, or place a gloved hand under the center of the brisket and the ends will droop.
• You can eat the brisket now. But there's one more optional step that will take your brisket from excellent to sublime: Let it rest. Place the wrapped brisket in an insulated cooler to rest for 1 to 2 hours, allowing the meat to relax and the juices to redistribute.
• To serve the brisket, unwrap it over a sheet pan to catch any juices trapped in the paper. Transfer the brisket to a cutting board (ideally, one with a well), lean flat section down. Cut the brisket in half crosswise, separating the flat section from the point section. The corner of the flat furthest from the sliced side may be tough and dry. Make a diagonal cut to remove it. Dice it and serve as burnt ends to thank onlookers for their patience. Look for the grain of the meat. Using a serrated knife or sharp carving knife, slice this section as thickly or as thinly as desired. (Texas tradition calls for slices that are the thickness of a pencil.) If your brisket has somehow come out tough, slice it paper-thin, which will make it seem more tender.
• Now slice the point section: Again, trim off and discard any obvious large lumps of fat. Slice the meat across the grain into 1/4-inch-thick slices (or as desired). Arrange the slices on a platter or plates and spoon the reserved meat drippings over them. It's nice to serve the meat by itself so you can appreciate the complex interplay of salt, spice, smoke, meat and fat. Texas tradition calls for sliced factory-style white bread. If you opt for barbecue sauce, serve it on the side.

TEXAS-STYLE BRISKET

Steps:

• Trim fat on brisket to 1/2-inch thickness. Rub brisket with pepper and salt; place in a large disposable foil pan, fat side up. Refrigerate, covered, several hours or overnight. Meanwhile, soak wood chips in water., To prepare grill for slow indirect cooking, adjust grill vents so top vent is half open and bottom vent is open only a quarter of the way. Make 2 arrangements of 45 unlit coals on opposite sides of the grill, leaving the center of the grill open. Light 20 additional coals until ash-covered; distribute over unlit coals. Sprinkle 2 cups soaked wood chips over lit coals., Replace grill rack. Close grill and allow temperature in grill to reach 275°, about 15 minutes., Place foil pan with brisket in center of grill rack; cover grill and cook 3 hours (do not open grill). Check temperature of grill periodically to maintain a temperature of 275° throughout cooking. Heat level may be adjusted by opening vents to raise temperature and closing vents partway to decrease temperature., Add another 10 unlit coals and 1 cup wood chips to each side of the grill. Cook brisket, covered, 3-4 hours longer or until fork-tender (a thermometer inserted in brisket should read about 190°); add coals and wood chips as needed to maintain a grill temperature of 275°., Remove brisket from grill. Cover tightly with foil; let stand 30-60 minutes. Cut brisket across the grain into slices.