Chinese Flatbread Recipes

SHAO BING

Steps:

• To make the roux, in a small pan over medium heat, heat the oil for 1 minute, or until the surface starts to shimmer slightly. Add the flour and, using a heatproof spatula or a small whisk, stir quickly to combine. Reduce the heat to low. Stir the mixture constantly for about 3 minutes, or until the color of the roux resembles peanut butter. Remove the pan from the heat. Continue to stir for about 1 minute, letting the residual heat from the pan brown the roux even more. Scrape the roux into a heatproof bowl and set aside.
• To make the shao bing, put the flour in a large bowl. Add the boiling water and, using a spatula or a wooden spoon, stir quickly to distribute. Add the cold water and stir to combine. As the dough forms, you can use your hands to start bringing the dough together. If it feels too dry, you can add 1 to 2 tablespoons warm tap water. Once you've worked all the flour into the mound of dough, take the dough out of the bowl and knead it on a work surface for 2 minutes, or until smooth. The dough should feel damp but not sticky.
• Lightly dust your work surface with flour. Roll out the dough into a rectangle about 18 inches long by 12 inches wide and ¼ inch thick; be sure the longer edge is parallel to the edge of your work surface. Stir the roux a few times. Using a spatula or large spoon, spread about 4 tablespoons of the roux on the dough, leaving a ½-inch border around the edge. Sprinkle the salt over the roux. (It may seem like it's too much salt but it isn't.)
• Starting from the longer edge of the rectangle, roll the dough into a cylinder, then seal the ends by pinching the edges together to create a seam. Cut the cylinder of dough into 8 equal segments.
• Preheat the oven to 450 degrees F. Line a baking sheet with parchment paper. Set aside.
• Turn each segment of the dough so that the seam is on the bottom and the cut edge (where you see the coil of dough) is facing you. Roll out the dough into a rectangle about 5 inches long by 3½ inches wide and ¼ inch thick. Flip the rectangle so that the seam side is now facing up. Trifold the rectangle as if you were folding a letter. With the folded edge perpendicular to you, roll out the dough again into a rectangle about 5 inches long by 3½ inches wide. Repeat the trifold and set aside, with the flap facing down. Repeat with the remaining pieces of dough.
• Put the sesame seeds on a small plate. Brush a little water on the surface of each piece of dough. Dip the moistened sides into the sesame seeds. With the seed side up, roll each dough into a rectangle about 5 inches long by 3½ inches wide and ¼ inch thick. Place the bread on the prepared baking sheet. Repeat with the remaining dough. Bake for 15 minutes, then flip the breads and bake for 4 minutes more, or until the breads puff up and have a lightly browned color on the surface.
• Remove the breads from the oven and let them cool slightly before serving.

CHINESE FLATBREAD

Steps:

• Mix flour wand water (as needed) to form a smooth (not too sticky though) dough.
• Let rest for 10 minutes.
• Divide dough into 3 pieces and use a rolling pin to roll the dough out into a large sheet.
• Spread oil (as needed) evenly on the sheet.
• Roll the sheet and divide it further into 3 qual parts.
• roll it out to approx 1/2 cm thick.
• fry them in a pan with oil.