Canned Salsa That Tastes Like Fresh Salsa Recipes

THE BEST CANNING SALSA

Steps:

• Combine tomatoes, onions, vinegar, tomato paste, green bell peppers, red bell peppers, banana peppers, sugar, garlic, pickling salt, and black pepper in a large stockpot; bring to a boil, reduce heat to medium-low, and simmer for 30 minutes. Mix cilantro into salsa.
• Sterilize the jars and lids in boiling water for at least 5 minutes. Pack salsa into hot, sterilized jars, filling to within 1/4 inch of the top. Run a knife or thin spatula around the insides of the jars after they have been filled to remove any air bubbles. Wipe the rims of the jars with a moist paper towel to remove any food residue. Top with lids and screw on rings.
• Place a rack in the bottom of a large stockpot and fill halfway with water. Bring to a boil and lower jars into the boiling water using a holder. Leave a 2-inch space between the jars. Pour in more boiling water if necessary to bring the water level to at least 1 inch above the tops of the jars. Bring the water to a rolling boil, cover the pot, and process for 35 minutes.
• Remove the jars from the stockpot and place onto a cloth-covered or wood surface, several inches apart, until cool. Once cool, press the top of each lid with a finger, ensuring that the seal is tight (lid does not move up or down at all). Store in a cool, dark area.

CANNED SALSA THAT TASTES LIKE FRESH SALSA

Steps:

• Prepare jars by sanitizing them in bleach water, or in a hot rinse cycle in the dishwasher.
• Wash vegetables.
• Chop Peppers and Onions with a food processor or blender. Dump in a very large mixing bowl.
• Add spices and vinegar to the mixing bowl.
• Add Lime Juice and chopped Cilantro (optional) to the mixing bowl.
• Core and chop Tomatoes with a food processor or blender. You can peel beforehand if you'd like, but I rarely peel my tomatoes for this salsa recipe.
• Strain the juice from the tomatoes before adding to the mixing bowl. I like to catch the tomato juice and can it to use in soups.
• Combine all ingredients. Taste with a torilla chip. Adjust the heat by adding more tomatoes (for milder taste) or more jalapenos (for a spicier taste).
• Fill jars with salsa. Wipe the rim clean, and top with a lid and ring.
• Process jars for 45 minutes. (adjust based on altitude)

FRESH SALSA

Steps:

• In a bowl, combine all ingredients; mix well. Let stand for about 1 hour. Serve at room temperature. Store in a covered container in the refrigerator.

CANNED (BOTTLED) SALSA

Steps:

• Bring a large pot of water to a boil.
• Blanch the tomatoes by dropping them into the boiling water for one minute. You will need to do them in batches.
• Transfer them to a large bowl or sink full of cold water.
• Fish them out and peel them.
• Chop them coarsely and sprinkle with pickling salt in layers as you go - I try to use about 4 tablespoons.
• Put them in a strainer and set in a cool place (but NOT the fridge!) to drain for several hours.
• When you are ready to procede, put all the canning jars in a large canner full of water to cover by one inch, and bring to a boil.
• Boil for 10 minutes.
• If your water is very hard, add a shot of vinegar to the water before it boils (to prevent lime build-up on bottles).
• Meanwhile, peel and chop the onions.
• Peel and deseed the peppers, and chop them.
• Peel and mince the garlic.
• Mix the tomato paste with cupful of the tomatoes until it is lump-free.
• Mix all the ingredients except the lime juice in a large kettle or pot.
• Bring the salsa to a boil.
• Lift the sterilized jars from the boiling water bath and empty them.
• (Most should be emptied into the sink, so the boiling water bath doesn't overflow when they go back in).
• Add 3 tbsps lime juice to each jar.
• Pack the salsa into the jars.
• Wipe rims, and seal according to manufacturer's instructions.
• (Generally, boil lids and rings for 5 minutes).
• Return the bottles to the boiling water bath and process them for 20 minutes. It may be necessary to do this in two batches; put as many in the canner as you are able to; when they come out add the next batch of jars to be sterilized while you fill the first set. Take them out and fill them as the first set of filled jars is being processed.
• Remove, allow to cool, and check seals.