Bling Pops Recipes

BLACK AND WHITE KEY LIME CAKE POPS

Steps:

• For the cake: Preheat the oven to 350 degrees F. Line a 9-by-12-by-2-inch cake pan with parchment, then grease and flour.
• In a large mixing bowl, mix the gelatin, granulated sugar, flour, baking powder, baking soda and salt. Add the orange juice, vegetable oil, lemon juice, lemon zest, vanilla and eggs. Mix well until combined. Pour the batter into the prepared pan and bake until an inserted toothpick comes out clean, 35 to 40 minutes. Let cool in the pan for 5 minutes, then turn out onto a cooling rack to cool completely.
• For the frosting: Beat the butter and cream cheese in a medium bowl until smooth, then beat in the lime juice. Beat in the confectioners' sugar until the mixture is smooth and easy to spread.
• To form the cake pops: Break up the cake into small pieces and place in a bowl. Add the frosting and mix very well with your hands to completely distribute the frosting. Line 2 small baking pans with parchment. Roll the cake mixture into about 46 tight balls, a little smaller than Ping-Pong balls, arranging them on the prepared baking pans. Freeze the balls on the pans until firm, about 30 minutes.
• For the coating: Put about 1/4 cup of the candy melting wafers in a small-microwave safe bowl and melt according to package directions. Dip the tip of 6-inch treat sticks in the melted candy and then insert one into each cake ball. Freeze until firm, about 30 minutes.
• Melt the rest of the candy melting wafers in a large bowl. Dip the balls in the candy to coat completely, letting the excess drip off; stick the pops into two 12-by-6-inch Styrofoam block. Freeze or refrigerate the pops until set.
• Put the chocolate and coconut oil in a wide, shallow microwave-safe bowl and microwave, stirring every 30 seconds, until melted. Dip one side of the cake balls into the chocolate so that they are half white and half black. Return to the Styrofoam blocks and freeze or refrigerate until set.

CHOCOLATE CANDY BAR ROUNDS

Steps:

• For the chocolate layer: Combine the chocolate chips and coconut oil in a double boiler over low heat. Heat until melted and stir until smooth. Let sit until thickened slightly, 10 to 15 minutes.
• Spoon 1 tablespoon of the chocolate mixture into each cavity of a 6-cavity round cylinder silicone mold (2-inch-wide by 1-inch-deep cavities). Use a small pastry brush to paint the chocolate up the sides of the molds, making sure to cover the entire inside of each mold. (If your chocolate is too hot and doesn't coat the molds, refrigerate for a few minutes, then try again.) Refrigerate or freeze until set, about 10 minutes.
• For the nougat layer: Stir the marshmallow creme and peanut butter together in a small bowl. It should be the consistency of putty.
• For the caramel layer: Put the caramel sauce in a separate bowl. Stir in the confectioners' sugar 1 tablespoon at a time, until the mixture is thick but still pourable.
• For the assembly: Grease 2 teaspoons with coconut oil spray. Use the teaspoons to place a heaping tablespoon of the nougat into each mold, pressing to make a smooth layer. Sprinkle over the peanuts and press into the nougat. Use the same teaspoons to add a heaping tablespoon of the caramel to each mold, stopping about 1/4 inch from the top of the molds. Pour the remaining chocolate over the caramel and spread gently with a small offset spatula to completely cover the caramel. Refrigerate or freeze until set, at least 30 minutes.
• Remove the chocolates from the molds. Microwave the candy melting wafers in a microwave-safe bowl in 30-second increments, stirring in between each, until melted and smooth. Drizzle the melted white candy over top of the rounds and sprinkle over the popping candies to decorate.