Awsome Ribs Recipes

MEATHEAD'S LAST MEAL RIBS RECIPE

Steps:

• Prep. Rinse the ribs in cool water to remove any bone bits from the butchering.
• If the butcher has not removed the membrane from the under side, do it yourself. It gets leathery and hard to chew, it keeps fat in, and it keeps sauce out. To remove it, insert a butter knife under the membrane, then your fingers, work a section loose, grip it with a paper towel, and peel it off. If you can't get the skin off, with a sharp knife, cut slashes through it every inch so some of the fat will render out during the cooking. Click here to see more photos of how to skin 'n' trim ribs and here's a quickie 1 minute video of the technique.
• Trim the excess fat from both sides of the rack of ribs.
• Next it is time to add the salt. The rule of thumb is 1/2 teaspoon of kosher salt per pound of meat, but ribs are about 50% bone, so use about 1/4 teaspoon per pound. You can simply eyeball it by sprinkling on the same amount of salt you would sprinkle on the ribs if they were served to you unsalted. If you can, give the salt 1 to 2 hours to be absorbed. The process of salting in advance is called dry brining.
• Before adding a BBQ rub, be aware of double salt jeopardy! Rubs and spice blends are a great way to add flavor to meat, but almost all commercial rubs contain salt so be careful not to pre-salt the ribs if you plan on using one of these rubs otherwise they will be unbearably salty. Also note that some ribs sold in grocery stores are labeled as "enhanced" or "flavor enhanced" or "self-basting" or "basted," meaning that they have been injected with a brine at the packing plant so if you are using these you probably want to use a rub that doesn't include salt like our Meathead's Memphis Dust recipe.Some folks insist on putting the barbecue rub on the night before, but it isn't necessary. The molecules in spices are too large to penetrate more than a tiny fraction of an inch. Read this for the science.
• Before applying the rub, just coat the meat with a thin layer of water. The water helps dissolve the spices. A lot of cooks like to use mustard under the rub as a form of glue. Mustard is water, vinegar, and maybe white wine (all mostly water) with mustard powder mixed in. The amount of mustard powder is so small that by the time the water steams off and drips away, the mustard powder remaining is miniscule. My experience is that using a mustard slather makes little or no difference in the final outcome. If you want a mustard flavor, you will do much better by simply sprinkling it on the meat. Once wet, sprinkle enough Meathead's Memphis Dust to coat all surfaces but not so much that the meat doesn't show through. That is about 2 tablespoons per side depending on the size of the slab. Spread the Memphis Dust on the meat and rub it in.
• Fire up. Pre-heat your barbecue smoker or set up your grill for 2-zone (indirect) cooking. Adjust the dampers on your cooker to bring the temperature to about 225°F and try to keep it there throughout the cook. Cooking at 225°F will allow the meat to roast low and slow, liquefying the collagen in connective tissues and melting fats without getting the proteins knotted in a bunch. It's a magic temp that creates silky texture, adds moisture, and keeps the meat tender. If you can't hit 225°F, get as close as you can. Don't go under 200°F and try not to go over 250°F.When monitoring the cooker temperature you can absolutely positively noway nohow rely on bi-metal dial thermometers. If you are not monitoring your cooker with a good digital oven thermometer, you are setting yourself up for disappointment. Using a dial thermometer is like trying to send email with a typewriter. Click here to read my buyer's guide to thermometers.Once you have reached the desired temperature, add about 4 ounces of dry wood, placing it as close to the flame as possible.
• Cook. Put the slabs in the cooker in indirect heat, meaty side up, close the lid, go drink a beer, read a book, or make love.
• When the smoke dwindles after 20 to 30 minutes, add another 4 ounces of wood. After that, DO NOT add any more wood. On your first attempt, resist the temptation. Nothing will ruin a meal faster and waste money better than over-smoked meat. You can always add more the next time you cook, but you cannot take it away if you over-smoke.
• If you have more than one slab on, halfway through the cook you will need to move the ribs closest to the fire away from the heat, and the slabs farthest from the flame in closer. Leave the meat side up. There is no need to flip the slabs. You can peek if you must, but don't leave the lid open for long.
• This next step is known as the Texas Crutch. This optional trick involves wrapping the slab in foil with about an ounce of water for up to an hour to speed cooking and tenderize a bit. Almost all barbecue ribs competition cooks use the Texas Crutch to get an edge. But the improvement is really slight and I never bother for backyard cooking. If you crutch too long you can turn the meat to mush and time in foil can soften the bark and remove a lot of rub. I recommend it only for barbecue competitions when the tiniest improvement can mean thousands of dollars. Skip it and you'll still have killer ribs. But if you've seen it on TV and must try it, click here to learn more about The Texas Crutch. The Texas Crutch is it is baked into a popular technique called the 3-2-1 method which I do not recommend. Two hours in foil or butcher paper is far too long and can make the meat mushy. Try the Texas Crutch after you master the basics.
• For cooking time, allow 5 to 7 hours for St. Louis Cut (SLC) Ribs or Spare Ribs, and 3 to 5 hours for Baby Back Ribs. Thicker, meatier slabs take longer. If you use rib holders so they are crammed close to each other, add another hour.
• When it is time to find out whether or not the ribs are ready, we us the bend test (a.k.a. the bounce test). Although we insist that you buy a good digital meat thermometer for most smoking and grilling, this is one of the few meats on which you cannot use a meat thermometer because the bones have an impact on the meat temp and because the meat is so thin. To conduct the bend test, pick up the slab with tongs and bounce it gently. If the surface cracks as in the picture above, it is ready. Here are some other tricks to tell when ribs are ready.
• Once the ribs are done cooking it is time to add the sauce unless you intend to serve them "dry" like they do in Memphis. The key to saucing ribs is to go easy on it so that the meat can shine through. Simply paint both sides of the rack with your favorite home made barbecue sauce or store-bought barbecue sauce and cook for another 15 minutes or so. Don't put the sauce on earlier than that. It has sugar and there is a risk it can burn. Now here's a trick I like: Sizzle on the sauce. Put the ribs with sauce directly over the hottest part of a grill in order to caramelize and crisp the sauce. On a charcoal grill, just move the slab over the coals. On a gas grill, crank up all the burners. On a water smoker, remove the water pan and move the meat close to the coals. On an offset smoker, put a grate over the coals in the firebox and put the meat there. With the lid open so you don't roast the meat from above, sizzle the sauce on one side and then the other. The sauce will actually sizzle and bubble. Stand by your grill and watch because sweet sauce can go from caramelized to carbonized in less than a minute! One coat of a thick sauce should be enough, but if you need two, go ahead, but don't hide all the fabulous flavors under too much sauce. If you think you'll want more sauce, put some in a bowl on the table.
• Serve. Once sauced, slice the rack between the bones. If you've done all this right, you will notice that there is a thin pink layer beneath the surface of the meat. This does not mean it is undercooked! It is the highly prized smoke ring caused by the combustion gases and the smoke. It is a sign of Amazing Ribs. Now plate, serve to your guests, and take a bow when the applause swells from the audience.

AWESOME RIBS FOR PORK OR BEEF

Steps:

• Cut ribs into individual ribs, and place all the pieces in large roasting pan.
• Scatter the thickly sliced onions over the ribs.
• Sprinkle lemon juice over the ribs.
• Bake for one hour in an oven that has been pre-heated to 350 degrees.
• Pour off ALL the fat and juice that has accumulated.
• In the meantime, make the sauce.
• To make the sauce, combine the last five ingredients in a saucepan, and cook (boil) for 20-25 minutes. Stir frequently. You want the sauce to cook down and thicken up.
• Dip cooked ribs into the sauce, and place in roasting pan. It's best if you make a single layer of ribs at this stage so, if necessary, use more than one pan.
• Dip cooked onions into sauce, and scatter over ribs.
• At this stage, you can refrigerate the concoction (covered with cling wrap) for a day or two -- so the flavours can really meld.
• Cook ribs a second time-for 30-60 minutes-in an oven that has been pre-heated to 325°F If you have refrigerated the concoction, take out of the fridge at least two hours before the second cooking. Thanks to Heystopthatnow for alerting me to the fact that I had omitted a cooking time for this step.
• Before the second cooking, baste the ribs. Then baste them again every 10 minutes. You want the ribs to be saucy.
• Serve with corn cobs, baked potatoes and salad. Garlic bread is nice, too.

THE MOST AMAZING TASTING RIBS IN THE WORLD!

Steps:

• In a small bowl mix rub ingredients.
• Season ribs all over, putting more on the meaty side than on the bone side. Do not press spices into the meat. Put ribs in a rib rack all facing the same direction.
• Make sure the charcoal in your barbecue covers no more than 1/3 of the grate. Place a large disposable drip pan on the other side of the charcoal grate. Fill the pan about half way with warm water.
• Drain 1 hand full of hickory chips and place them on top of the charcoal. Put the cooking grate in place. Place the rib rack over the drip pan as far from the charcoal as possible, with the bone sides facing the charcoal. Close the lid. Close the top vent about halfway. Let the ribs cook and smoke for about one hour. Maintain temperature between 250°F and 300°F by opening and closing the top vent. Meanwhile, make the sauce and the mop.
• In a small saucepan mix the barbeque sauce ingredients. Simmer for a few minutes over medium heat, and then remove the sauce pan from the heat.
• In another small saucepan mix the mop ingredients. Simmer over medium heat for a few minutes to melt the butter, and then remove the saucepan from the heat.
• After the first hour of cooking add 8 - 10 charcoal briquettes and the remaining handful of hickory chips (drained) to the fire. At the same time lightly baste the ribs with some mop. Leaving the lid off for a few minutes while you mop the ribs will help the new briquettes to light. Close the lid and cook for another hour. During that time maintain the temperature at 250°F - 300°F by opening and closing the top vent.
• After another hour of cooking add 8 to 10 more briquettes to the fire. Remove the ribs from the rib rack, spread them over a clean work surface, and based them generously with the mop sauce. You may add 2 more tablespoons of barbecue sauce to the mop sauce if you wish. Put them back in the rib rack, again all facing the same direction, but this time turned over so that the ends facing down earlier now face up. Also, reposition any ribs that appear to be cooking faster to the back of the rib rack, farther from the charcoal. Let the ribs cook for a 3rd hour. During that time, maintain temperature of 250°F - 300°F.
• After 3 hours of cooking, check to see if any racks are ready to come off the grill. They are done when the meat has shrunk back from most of the bones by 1/4 inch or more. When you lift a rack by picking it up from one end with tongs, the rack should bend in the middle and the meat should tear easily. If the meat does not tear easily, continue to cook the ribs. The total cooking time could be anywhere from 3 to 4 1/2 hours. Not all racks will cook in the same amount of time. Baste the ribs with the barbeque sauce and, if desired for crispiness, cook them over direct heat for a few minutes. Transfer to a baking sheet and tightly cover with aluminum foil. Let rest for 10 - 15 minutes before serving. Serve warm with the remaining sauce on the side.

AWSOME RIBS

Steps:

• 1.Cut ribs into small portions of 2 or 3 bones each. Bring a large pot of water to a boil. Season water a pinch each of salt, black pepper, and crushed red pepper to the water. Boil ribs in seasoned water for 20 minutes. Drain, and let the ribs sit for about a half an hour.
• 2.Meanwhile, preheat an outdoor grill for high heat.
• 3.Lightly coat the ribs with barbecue sauce. Cook the ribs over high heat for a 5 to 10 minutes on each side to get a nice grilled look to them.
• 4.Place grilled ribs in a slow cooker. Pour remaining barbecue sauce and one bottle of beer over the ribs; this should cover at least half of the ribs. Cover, and cook on High for 3 hours. Check ribs every hour or so, and add more beer if needed to dilute sauce. Stir to get the ribs on top into the sauce. The ribs are done when the meat is falling off the bone. The ribs were cooked completely in the first process, the rest is about flavor and texture.