Tempered Chocolate For Caramallows Recipes

TEMPERED CHOCOLATE

Steps:

• Place 1/2 pound chocolate in a metal (or other heatproof) bowl. Bring a saucepan containing 2 inches of water to a simmer, then turn off heat. Set bowl of chocolate over saucepan (don't let bottom touch the water) and let melt, stirring gently with spatula until chocolate registers 118 degrees to 120 degrees on thermometer. Remove bowl; cover saucepan to keep water warm.
• Add remaining 1/4 pound chocolate to bowl, stirring constantly until chocolate registers 82 degrees on thermometer. Remove any unmelted pieces of chocolate with spatula. Line bottom of bowl with a kitchen towel and return to saucepan, stirring constantly until chocolate registers 88 degrees to 90 degrees. (The towel will help ensure the chocolate does not climb above 90 degrees, which would cause it to "bloom" when set.) Use immediately, stirring frequently while using to maintain temper and prevent streaking once chocolate hardens. If tempered chocolate thickens too much during use, place over simmering water again, stirring, 2 to 3 seconds.

CHOCOLATE-DIPPED CARAMALLOWS

Steps:

• Make first caramel layer: Coat a rimmed 12 1/2-by-17 1/2-inch baking sheet with cooking spray. Line with parchment, leaving a 2-inch overhang on 2 sides, then coat parchment with spray.
• Place 2 cups cream, 2 cups sugar, 1 cup corn syrup, and 6 tablespoons butter in a large pot. Bring to a boil, stirring until sugar dissolves and butter melts, about 5 minutes. Cook over medium heat, stirring often, until mixture registers 245 degrees on a candy thermometer, about 20 minutes. Remove pot from heat, and stir in 3/4 teaspoon salt and 1/2 teaspoon vanilla. Pour into prepared pan without scraping bottom of pot. Let stand.
• Make the marshmallow layer: Sprinkle gelatin over 1/3 cup water in a mixer bowl, and let soften, about 5 minutes.
• Mix sugar and remaining cup water in a small saucepan over medium-high heat, stirring until sugar dissolves. Wash down sides of pan with a wet pastry brush to prevent sugar crystals from forming. Cook, undisturbed, until mixture registers 238 degrees on a candy thermometer, about 10 minutes. (You may have to tilt pan to get an accurate read.) Remove pan from heat, and whisk sugar syrup and a pinch of salt into gelatin. Pour into a mixer bowl, and whisk on medium-high until cool and thick, about 10 minutes. Spread marshmallow evenly over caramel to cover, and let stand for 30 minutes.
• Prepare second caramel layer with remaining ingredients as in step 2. Pour over marshmallow layer, covering entire surface, and let stand, uncovered, until set, about 8 hours.
• Using a 1 1/4-inch round cutter, cut out 70 rounds. Using a fork, dunk each round in chocolate. Scrape bottom of fork against edge of bowl to remove excess, and place dipped candies on a parchment-lined baking sheet. Sprinkle nonpareils on top, and let stand until set.

TEMPERED CHOCOLATE (FOR USE IN MOLDING AND SCULPTING)

Steps:

• Chocolate melts best at temperatures between 104 and 113 degrees F (40 degrees C and 45 degrees C). Never melt chocolate directly over a heat source. Use an indirect source like a hot water bath.
• Tempering determines the final gloss, hardness, and contraction of the chocolate. When you melt chocolate, the molecules of fat separate. To put them back together, you temper it. There are a variety of ways to do it. One of the easiest ways is to place it in the microwave for 30 seconds at a time on high power until the chocolate is melted. Be very careful not to overheat it. The chocolate will not look as if it has melted because it retains its shape. It should be only slightly warmer than your bottom lip. You may still see lumps in it, but don't worry; the residual heat of the chocolate will melt them. You can also use an immersion blender to break the lumps and start the recrystallization process.
• Usually, the chocolate begins to set (recrystallize) along the side of the bowl. As it begins to crystallize, mix those crystals into the melted chocolate and they will begin recrystallization process. I like to use a glass bowl because it retains the heat and keeps the chocolate tempered for a long time.
• Another way to temper chocolate is called seeding. In this method, tempering is achieved by adding small pieces of unmelted chocolate to melted chocolate. The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate but is usually one fourth of the total amount. I usually use an immersion blender to mix the two together.
• The classic way to temper chocolate is called tabliering. Chocolate is melted over hot water bath to a temperature between 88 degrees F and 90 degrees F (31 degrees C and 32 degrees C). (White and milk chocolate are melted to a temperature approximately 2 degrees F less, depending on the amount of milk fat they contain.) Two thirds of the melted chocolate is poured on a cold table marble surface. The chocolate is spread out and worked with a spatula until the temperature of the chocolate is approximately 81 degrees F (27 degrees C). At this stage, it is thick and begins to set. This tempered chocolate is then added to the remaining one third of nontempered chocolate and mixed thoroughly until the mass in the bowl has a completely uniform temperature. If the temperature is still too high, part of the chocolate is further worked on the cold table until the correct temperature is reached. This is a lot of work, requires a lot of room, and makes a big mess.
• A simple method to check tempering is to apply a small quantity of chocolate to a piece of paper or to the point of a knife. If the chocolate has been tempered correctly, it will harden evenly and show a good gloss within 5 minutes.
• Storing Chocolate:
• Chocolate is susceptible to moisture and absorbs external odors. It is also important to protect it from light and air. Store it in a cool, dry place in closed packaging. The ideal temperature for storing chocolate is between 54 degrees F and 68 degrees F, (12 C and 20C). Do not store chocolate in the refrigerator, where the humidity (moisture) will affect it.

HOW TO TEMPER CHOCOLATE

Steps:

• Tempering Chocolate: Tempering is important because it determines the final gloss, hardness, and contraction of the chocolate. When you melt chocolate, the molecules of fat separate. In order to put them back together, you temper it. There are a variety of ways to do it.
• One of the easiest ways to temper chocolate is to place it in the microwave for 30 seconds at a time on high power until the chocolate is melted. Be very careful not to overheat it. The chocolate should be only slightly warmer than your bottom lip, and it will retain its shape even when mostly melted. Any remaining lumps will melt in the chocolate's residual heat. You can also use an immersion blender to break up the lumps and start the recrystallization process. Usually, the chocolate begins to set, or crystallize, along the side of the bowl. As it sets, mix those crystals into the melted chocolate to temper it. I like to use a glass bowl because it retains the heat and keeps the chocolate tempered longer.
• Another way to temper chocolate is called seeding. In this method, tempering is achieved by adding small pieces of unmelted chocolate to melted chocolate. The amount of unmelted chocolate to be added depends on the temperature of the melted chocolate but is usually 1/4 of the total amount. I usually use an immersion blender to mix them together.

TEMPERED CHOCOLATE FOR TRUFFLES

Steps:

• Place 1/2 pound chocolate in a metal bowl. Bring a saucepan with 2 inches of water to a simmer, and then turn off heat. Set bowl with chocolate over saucepan, and let melt, stirring gently with a rubber spatula until chocolate registers 118 degrees on a candy thermometer. (Watch the chocolate carefully, as heating and cooling times can vary.) Remove bowl from saucepan.
• Add 1/4 pound unmelted chocolate to bowl and stir until chocolate cools to 84 degrees. (Remove any unmelted pieces with spatula.) Return bowl to saucepan, and let stand, and stir until chocolate registers 88 to 90 degrees. Use immediately. Repeat with remaining chocolate.

JACQUES TORRES'S TEMPERED CHOCOLATE

Steps:

• Place chocolate in a large microwaveable bowl. Microwave in 20-second intervals, stirring after each interval. Remove bowl from microwave when two-thirds of the chocolate is fully melted and one-third is still in pieces.
• Using a rubber spatula, transfer all of the chocolate to a room-temperature bowl. Carefully, using an immersion blender fully submerged in the chocolate, blend the chocolate until smooth. Using a laser thermometer, check the temperature. If the temperature is less than 90 degrees, use a hair dryer to heat up the chocolate while stirring continuously. If the temperature is more than 90 degrees, continue to stir, adding more pistoles or chopped chocolate to cool it down. When the temperature is 90 degrees, it is tempered and ready to use. If there is any leftover tempered chocolate, it may be stored in a re-sealable plastic bag and reserved for another use.

HOW TO TEMPER CHOCOLATE

Steps:

• 1. Finely chop 1 1/2 to 2 pounds chocolate. Smaller amounts make it difficult to control the temperature changes.
• 2. Place two-thirds of the chocolate in a double boiler or metal bowl set over a saucepan of simmering water. Make sure the bottom of the bowl does not touch the water. Place a candy thermometer or digital thermometer in the chocolate and stir frequently with a rubber spatula.
• 3. Do not let the temperature of the chocolate exceed 120°F for dark chocolate or 105°F for milk or white chocolate. When the chocolate has fully melted, remove the bowl from heat. Wipe the bottom of the bowl to get rid of any condensation.
• 4. Stir in the remaining third of the chocolate a little at a time. Let it melt before adding more.
• 5. Let the chocolate cool to about 82°F. It it is warmer, keep stirring and let it cool some more. If it is cooler, begin reheating in the next step.
• 6. Once the chocolate is 82°F, place it back over simmering water. For dark chocolate, reheat to 88°F to 91°F. For milk and white chocolate, reheat to 85°F to 87°F. Remove the bowl from heat once you have reached the right temperature.
• 7. Spread a small spoonful of chocolate on a piece of wax paper. If it looks dull or streaky, re-temper the chocolate, starting with step 2. If it dries quickly with a glossy finish and no streaks, the chocolate is in temper.
• Keeping chocolate in temper
• Once melted chocolate has been tempered, it must be used before it cools and sets. If it cools to about 84°F to 86°F and is still fairly liquid, it can be reheated to a liquid consistency. If it has completely cooled and solidified, it should be re-tempered. Heat it for 5 to 10 seconds at a time, stirring and checking the temperature before reheating. For dark chocolate, reheat to 88°F to 91°F. For milk and white chocolate, reheat to 87°F to 88°F. If you keep your chocolate within these temperature ranges, it will stay in temper and be liquid enough to use.
• Easy alternatives to tempering chocolate
• Several products exist for those who do not want to temper chocolate. They are called confectionery coatings, coating chocolate, summer coating, or chocolate bark coatings. They are usually made of vegetable fats that melt smoothly and set up quickly to a finish that is very similar to tempered chocolate. They may not contain actual chocolate. Nothing can perfectly duplicate the taste and mouth-feel of tempered chocolate, but quality coatings can be good substitutes. They can be cooled and reheated quickly, and as often as necessary.

TEMPERED CHOCOLATE FOR CARAMALLOWS

Steps:

• Place 1/2 pound chocolate in a metal bowl. Bring a saucepan with 2 inches of water to a simmer, then turn off heat. Set bowl with chocolate over saucepan, and let melt, stirring gently with a rubber spatula until chocolate registers 118 degrees on a candy thermometer. (Watch the chocolate carefully, as heating and cooling times can vary.) Remove bowl from saucepan. Add 1/4 pound unmelted chocolate to bowl, and stir, until chocolate cools to 84 degrees. (Remove any unmelted pieces with spatula.) Return bowl to saucepan, and let stand, and stir until chocolate registers 88 degrees to 90 degrees. Use immediately. Repeat with remaining chocolate.