Soft Gingerbread Tiles With Rum Butter Glaze Recipes

SOFT GINGERBREAD TILES WITH RUM BUTTER GLAZE

Steps:

• Place the butter, sugar and molasses in the bowl of an electric mixer with the paddle attachment in place. Beat on medium speed until smooth and incorporated. Add the egg yolk and continue to beat until fully combined.
• Sift the flour, cocoa powder, baking soda, ginger, cinnamon, cloves, salt and pepper into a bowl. Turn the speed of the mixer to low, and add the dry ingredients to the butter and molasses. Once the mix comes together, tip the dough onto a lightly floured work surface and knead gently. Roll out the dough so that it is about 1/4 inch/ 0.5 cm thick. If the dough is very soft, you will need to chill it.
• Preheat the oven to 375°F/190°C. Line two baking sheets with parchment paper and set aside.
• Dip the cookie stamps in a small bowl of flour, shake off any excess and then press them firmly into the dough, one at a time, to create a deep imprint. How far you need to press to get an imprint will depend on your stamp; the patterns on some are more deeply cut than others. Bear in mind that the cookies rise a little when cooked, so any soft imprints will disappear. Using a round cookie cutter that is slightly larger than the pattern, cut out the pieces of imprinted gingerbread. Transfer the cookies to the lined baking sheets, spaced about 3/4 inch/2 cm apart. Reroll the dough and continue to stamp and cut cookies until all the dough is used up.
• Bake for 9-10 minutes, rotating the sheets halfway through, until firm to the touch. They will continue to firm up as they cool, so don't be tempted to bake them for any longer.
• To make the rum butter glaze while the gingerbreads are in the oven, as the glaze needs to be brushed onto the cookies while they are still warm, sift the confectioners' sugar and cinnamon into a small bowl. Add the melted butter, rum (or lemon juice) and water and mix with a spoon until smooth. The glaze will thicken slightly if it sits around, so stir through a little more warm water if you need to-it should be the consistency of runny honey.
• Remove the cookies from the oven, leave them to cool for 5 minutes, then brush or dab the glaze all over with a pastry brush. Transfer to a wire rack to cool completely.
• Make-Ahead
• Once the dough is made, it can be covered in plastic wrap and kept in the fridge for up to 2 days before baking.
• Storage
• These will keep for up to 5 days in an airtight container. The glaze will discolor and crack a little, but this will not affect how they taste.

TARTINE'S SOFT GLAZED GINGERBREAD

Steps:

• To make the dough, stir together the flour, cocoa powder, ginger, cloves, cinnamon, baking soda, salt, and pepper in a mixing bowl. Set aside.
• Using a stand mixer fitted with the paddle attachment, beat the butter on medium-high speed until creamy. Slowly add the granulated sugar and mix on medium speed until the mixture is completely smooth and soft. Stop the mixer and scrape down the sides of the bowl with a rubber spatula as needed.
• Add the egg and mix well. Add the molasses and corn syrup and beat until incorporated. Stop the mixer again and scrape down the sides of the bowl.
• Add the flour mixture and beat on low speed until a dough forms that pulls away from the sides of the bowl and all the ingredients are well incorporated.
• Remove the dough from the bowl, flatten it on a large piece of plastic wrap into a rectangle about 1 inch thick, cover the dough with the plastic wrap, and refrigerate overnight.
• Preheat the oven to 350 degrees. Line a baking sheet with parchment paper or a nonstick liner.
• Unwrap the dough and place on a floured work surface. If using a plaque with a design, roll out the dough 1/3 inch thick, lightly dust the top with flour, press your cookie molds over the dough, and then cut out the shapes with a small knife and place on the prepared baking sheet, spacing them about 1 inch apart. Alternatively, using the mold as a guide, cut around it with a small knife, flip the mold over so the design is facing you, and place the dough over it, pressing it into the design. Unmold the shapes onto the prepared baking sheet, leaving about 1 inch between them.
• If using a patterned rolling pin, lightly dust the lined baking sheet with flour and transfer the dough to the pan. Lightly dust the top of the dough with flour and roll it into a rectangle about 1/3 inch thick with a plain pin. Then, using the patterned pin, roll over the dough with enough pressure to ensure a clear impression of the design. Trim the sides with a small knife. It is not necessary to cut into smaller sizes before baking.
• Bake the cookies until lightly golden along the sides but still soft to the touch in the centers, 7 to 15 minutes. The timing will depending on the size of the individual cookies, or if you have made a single large patterned piece that will be cut after baking.
• While the cookies are baking, prepare the glaze. In a small bowl, whisk together the confectioners sugar and water until smooth.
• When the cookies are ready, remove from the oven and let cool on the pan on a wire rack for about 10 minutes. Then, while the cookies are still warm, using even strokes, brush a light coat of glaze on the top of each cookie, evenly covering it.
• Let the cookies cool completely. When the glaze dries, it should leave a shiny, opaque finish. If you have used a patterned pin to make a single large plaque, cut into the desired sizes with a small, very sharp knife. At the bakery, we cut them into 3-by-4-inch rectangles, but 1 1/2 by 4 inches makes a nice smaller size.