Peanut Rocky Road Bark Recipes

NO-BAKE ROCKY ROAD BARS

Steps:

• For the bars: Line a 9-by-13-inch baking pan with parchment so that the edges fold over the sides of the pan. Spray with cooking spray.
• Add the sweetened condensed milk, cream cheese and butter to a medium pot and place over low heat. Cook, whisking occasionally so the bottom does not brown, until melted and well combined, a few minutes.
• Put the pecans, walnuts, graham crackers and marshmallows in a bowl; set aside.
• When the cream cheese mixture has melted, whisk until well combined, and then remove from the heat. Fold in the chocolate chips and mix until all the chocolate is melted and the mixture is well combined.
• Pour the chocolate mixture into the bowl with the graham cracker mixture. Pour the mixture into the prepared pan and place in the fridge for 1 to 1 1/2 hours to set.
• For the quick marshmallow frosting: In the bowl of stand mixer fitted with the paddle attachment, beat the sugar and butter until creamy, a couple of minutes. Beat in the marshmallow creme.
• Remove the set mixture from the pan. Cut into squares and frost with or dip in the marshmallow frosting. Keep refrigerated.

ROCKY ROAD BARK

Steps:

• Place the chocolate in a food processor fitted with the blade attachment. Pulse 25 to 30 times or until the chocolate is the consistency of coarse breadcrumbs.
• Turn the food processor on and run for 1 minute until the chocolate becomes a mass. Stop the food processor and use a clean spatula to break up the mass, scraping the bottom and sides of the food processor. Leave the chocolate in the food processor for 1 minute without running or pulsing. Scrape down the sides and bottom of the processor after the 1-minute rest.
• Complete all the steps in the previous paragraph, 3 to 4 times or until the chocolate is smooth, fluid and reaches 90 to 91 degrees F. Do not let the chocolate go above 94 degrees F. If the chocolate is close to but not at 90 degrees, briefly heat with a 10-second blast of warm heat from a hair dryer until it reaches the correct temperature.
• Remove the food processor bowl from the base and the blade from the bowl. Continue scraping and stirring for 1 minute. Test the temper of the chocolate by spreading a small amount of chocolate in an even layer on a metal surface set over an ice pack. It should set within 3 minutes and be shiny and streak-free.
• If the temper test has some streaks, continue scraping and stirring for another minute and test again. The chocolate should maintain a temperature between 88 and 91 degrees F.
• As the chocolate begins to cool it will set on the sides of the food processor; as needed scrape down the sides of the bowl again and briefly heat with a 10-second blast of warm heat from a hair dryer until it is once again 91 degrees F.
• Stir two-thirds of the almonds and marshmallow creme into the chocolate just to combine and pour onto a sheet of parchment or a silicone mat set on a half sheet pan inverted over cold packs. Top with the remaining third of the almonds and marshmallow creme. Cool until set, approximately 30 minutes.
• Break into large pieces to serve. Store in an airtight container in a cool, dark place.

ROCKY ROAD

Steps:

• Grease a 9 x 9 inch pan.
• Heat chocolate chips and peanut butter over low heat in a medium saucepan until chips are completely melted. Remove from heat. Stir in marshmallows.
• Pour into prepared pan. Cool. Can be put into refrigerator to cool. Cut and Enjoy!