Crazy Cake Pops Recipes

EASY HOMEMADE CAKE POPS

Steps:

• Preheat oven to 350℉. Spray sheet cake pan or baking sheet with nonstick spray.
• In a large bowl, combine the cake mix, pudding mix, eggs, water and oil. Beat at medium speed with an electric mixer for 2 minutes. Pour into the prepared pan.
• Bake 35 to 40 minutes, or until a toothpick inserted in the center comes out clean. Cool cake in pan for 10 minutes, then remove from pan and cool completely. Divide cake in half and freeze one half for future use.
• Using your hands, crumble up the cake until no large pieces remain.
• Add frosting, mixing with fingers until well combined.
• Form into cake balls and chill until set, about 2 hours.Small cake pops: 1 tablespoon-sized cake balls (each about 1 1/4 inch diameter) makes about 48 cake pops.Medium cake pops: 2 tablespoons-sized cake balls (each about 1 1/2 inch diameter) makes about 24 cake pops.Large cake pops: 3 tablespoons-sized cake balls (each about 1 3/4 inch diameter) makes about 16 cake pops.
• While cake balls are setting, melt Candy Melts candy according to package instructions.
• Dip the tip of each lollipop stick into melted candy, then into set cake balls. Repeat with all cake balls, then let chill again until set, about 10 minutes. Reserve remaining melted candy.
• Dip the cake balls, one at a time, into remaining melted candy. Tap lightly to remove excess. If needed, you can reheat the candy with some EZ Thin Dipping Aid to thin it out for easier dipping.
• Immediately cover with sprinkles or topping of choice, then transfer to craft foam. Repeat with remaining cake pops. Chill until set, about 10 to 15 minutes.

SIMPLE CAKE POPS

Steps:

• Preheat oven to 350 degrees F (175 degrees C). Grease a 9x13-inch baking dish.
• Beat cake mix, water, eggs, and oil in a bowl using an electric mixer on low speed for 30 seconds. Increase speed to medium and beat for 2 minutes more. Pour batter into the prepared baking dish.
• Bake in the preheated oven until a toothpick inserted in the center comes out clean, 28 to 33 minutes. Cool completely, at least 1 hour.
• Crumble cake into a large bowl. Stir frosting into cake crumbles until mixture is sticky but not too smooth. Chill in refrigerator, at least 30 minutes.
• Roll cake mixture into 1 1/2-inch balls and arrange on a baking sheet. Place 1 lollipop stick into each ball.
• Melt about 1/4 cup chocolate candy melts in a microwave-safe bowl in the microwave, about 20 seconds. Dip each cake pop in the melted chocolate. Repeat melting chocolate and dipping remaining cake pops. Decorate pops with decorating icing.

CRAZY CAKE

Steps:

• Sift flour, sugar, salt, soda, and cocoa together into a 9 x 13 inch ungreased cake pan. Make three wells. Pour oil into one well, vinegar into second, and vanilla into third well. Pour cold water over all, and stir well with fork.
• Bake at 350 degrees F (175 degrees C) for 30 to 40 minutes, or until tooth pick inserted comes out clean. Frost with your favorite icing.

CAKE POPS

Steps:

• Prepare and bake the cake according to the package directions for a 9-by-13-inch pan. Let cool completely.
• Break the cake into pieces and place it in a food processor. Add the frosting and process until the mixture forms a ball and pulls away from the sides of the bowl, about 30 seconds. If the mixture doesn't come together, add more frosting 1 tablespoon at a time until it holds its shape.
• Using a 3/4-ounce scoop, form the mixture into 46 balls and put them on a baking sheet. Refrigerate until firm, about 30 minutes.
• Meanwhile, place the candy wafers in a microwave-safe bowl and melt according to package directions. Dip a half inch of the tip of a lollipop stick into the candy and then stick the tip halfway into a cake ball. Repeat with the remaining balls and sticks. Refrigerate the cake pops until completely chilled, about 1 hour.
• Microwave the candy again until melted and pour it into a tall narrow glass. Dip each cake pop into the candy and let any excess run off. If decorating, turn the cake pop upright and sprinkle with sprinkles while the coating is still wet. Stick the finished pops in two 9.8-by-11.8-inch Styrofoam blocks block and let set completely.