Brine For Corning Beef Recipes

HOMEMADE CORNED BEEF BRINE

Steps:

• To save time you can use store-bought pickling spices or you can make your own based on the ingredients above.
• Add the allspice berries, mustard seeds, coriander seeds, red pepper flakes, red and black peppercorns, cloves, and cardamom pods to a small frying pan over medium-low heat and toast until fragrant. This will take a minute or two, stir and keep an eye on the spices as they can easily burn.
• Remove from heat and place in a small bowl. Use a mortar and pestle to crush them. Add the crushed bay leaves and ground ginger and stir to combine.
• Add a gallon of water to a large pot and add 4 tablespoons of the pickling spices (saving the remaining ones for later), add the cinnamon stick, Kosher salt, and brown sugar. Bring to a boil, then remove from heat and let cool to room temperature. Then refrigerate until well chilled.
• Once chilled, place the beef brisket in a large, flat container or pan, and cover with the brine. Make sure the brine covers the meat. If the meat floats, weigh it down with a plate.
• Refrigerate for 5-7 days and every day flip the brisket over so that all sides get brined equally.
• Remove the brisket from the brine and rinse it with cold water.
• Place the brisket in a large pot and cover with at least one inch of water.
• Add the remaining pickling spices and bring to a boil, reduce to a very low simmer, and cook for 3-4 hours, until the corned beef is fork-tender.
• Once done, place the meat on a cutting board. Cut across the grain to serve.
• Add some veggies into the spiced cooking liquid, like cabbage and carrots, and cook them to serve with the corned beef.

BRINE FOR CORNING BEEF

Steps:

• Bring first 9 ingredients listed up to the peppercorns to a boil and boil hard for 5 minutes. Leave the brine to cool.
• Clean a stoneware crock or plastic bucket and its lid with a solution of 1 tablespoon baking soda to 1 gallon boiling water. Rinse well and leave to drain dry. To test the saltiness of the brine put egg, in shell in the cooled brine. If it doesn't float, add enough salt until it does.
• To draw off any excess blood and to help the brine penetrate, pierce the beef all over with a trussing needle or skewer and place meat in cold water for about 45 minutes.
• Remove the meat from water and place in crock or bucket. Pour the cooled brine over the brisket. Add garlic to the brine. Place a plate on top of the brisket to submerge. Place a lid or plastic wrap over container.
• Store in a refrigerator or dry place, at a temperature below 60 degrees. Salting time depends on the thickness of the meat. Allow 3 to 10 days for salting time for brisket.
• When removing meat from brine, always use clean tongs: this way the brine will stay good longer and be reused with the same kind of meat. It is possible to strain off the brine and reboil it, adding a refresher of about half the above quantities.
• Naturally the crock or bucket will need a complete cleaning. This should be done before mold appears.