Beer Butt Chicken Rub Recipes

BEER BUTT CHICKEN

Steps:

• Preheat an outdoor grill for low heat.
• In a small skillet, melt 1/2 cup butter. Mix in 1 tablespoon garlic salt, 1 tablespoon paprika, salt, and pepper.
• Discard 1/2 the beer, leaving the remainder in the can. Add remaining butter, garlic salt, paprika, and desired amount of salt and pepper to beer can. Place can on a disposable baking sheet. Set chicken on can, inserting can into the cavity of the chicken. Baste chicken with the melted, seasoned butter.
• Place baking sheet with beer and chicken on the prepared grill. Cook over low heat for about 3 hours, or until internal temperature of chicken reaches 180 degrees F (80 degrees C).

PAT'S BEER CAN GRILLED CHICKEN

Steps:

• For the chicken rub: In a small bowl mix all the ingredients together and use for the grilled chicken. You can store extra rub mixture in an airtight container for up to 6 months.
• For the chicken: Preheat your grill to medium-high heat.
• Rub the chicken and its cavity down with the vegetable oil. Season the chicken with rub mixture, remembering to season the cavity. Pour out 1/4 of the beer and sit the chicken on top of the beer can. Place the chicken in the center of the hot grill and cover. Cook the chicken for 1 to 1 1/2 hours, or until an instant-read thermometer registers 165 degrees F. Once cooked, cover loosely with foil and let rest for 10 minutes before carving.

ED'S FAVORITE BEER CAN CHICKEN RUB

Steps:

• Stir brown sugar, dry mustard, granulated onion, paprika, kosher salt, garlic powder, coriander, cumin, black pepper, and cayenne pepper together in a bowl.

BEER CAN CHICKEN

Steps:

• Preheat an outdoor grill for medium-high heat, about 375 degrees F (190 degrees C). Mix the brown sugar, chili powder, paprika, dry mustard, salt, and ground black pepper in a small bowl. Place the half-full can of beer in the center of a plate.
• Rinse chicken under cold running water. Discard giblets and neck from chicken; drain and pat dry. Fit whole chicken over the can of beer with the legs on the bottom; keep upright. Sprinkle 1 teaspoon of the seasoning mix into the top cavity of the chicken. The beer may foam up when the seasonings fall inside the can. Rub the remaining seasoning mix over the entire surface of the chicken.
• Place the chicken, standing on the can, directly on the preheated grill. Close the lid and barbeque the chicken until no longer pink at the bone and the juices run clear, about 1 hour 15 minutes. An instant-read thermometer inserted into the thickest part of the thigh, near the bone should read 180 degrees F (82 degrees C). Remove the chicken from the grill and discard the beer can. Cover the chicken with a doubled sheet of aluminum foil, and allow to rest in a warm area for 10 minutes before slicing.

SPICE RUBBED BEER CAN CHICKEN

Steps:

• Heat a gas or charcoal grill with a lid big enough to accommodate the bird. Put a drip pan below the grates.
• Mix the ingredients for the Spice Rub until they are well blended. (This will keep, covered, in the refrigerator for 1 week.) Rub it all over the chicken, inside and out.
• Open the beer and take a big swig or just pour out a couple of ounces. Sit the chicken on the beer can so the legs are at the bottom and the wings are at the top. Stand the beer can on the grates over the drip pan. Put the cover on and cook over indirect heat until the juices run clear, about 1 hour. (If using charcoal, push the coals to 1 side so the chicken is not over direct heat.)
• Note: This chicken can also be cooked in a 350 degrees F oven. Just stand the beer can in a shallow roasting pan and cook about 1 hour or until juices run clear.

BEER BUTT CHICKEN RUB

Steps:

• Combine all ingredients in a bowl and mix well.
• Sprinkle on whatever you want to grill and allow to dry marinate for 4 hours or overnight.
• Store any unused rub in an airtight container.

TEXAS DRY RUB BEER CAN CHICKEN

Steps:

• In a small bowl combine the rub ingredients.
• Remove and discard the neck, giblets, and any excess fat from the chicken. Rinse the chicken, inside and out, under cold water and pat dry with paper towels. Lightly spray or brush all over with the vegetable oil and season, inside and out, with the rub. Let rest at room temperature while you preheat your grill.
• Open the beer can an pour off half of the beer. (Or drink it if you don't want to waste it.) Set the half-full can of beer in can holder (or if you don't have a can holder, just be extra careful and place the can on a flat smooth surface), and add fresh rosemary leaves, minced shallot and lemon juice. This will help add moisture and flavor from the inside as your chicken cooks. You may need to use a funnel, to help add the ingredients to the can.
• Slide the chicken over the top so the can fits inside the cavity. Transfer the bird to your preheated grill, while carefully keeping the can upright. Carefully balance the bird on its two legs and the can holder. (If can holder is not used just use the can and use the legs like a tripod.) Grill over Indirect Medium heat until the juices run clear and the internal temperature reaches 170 F in the breast and 180 F in the thickest part of the thigh. 1 - 1/4 to 1 - 1/2 hours. Wearing barbecue mitts, carefully remove the chicken and the can (holder) from the grill. Do not spill the beer, it will be HOT. Let the chicken rest for about 10 minutes before lifting it from the can (holder). Discard the beer. Cut the chicken into serving pieces. Serve warm.
• ENJOY!

ULTIMATE BEER BUTT CHICKEN BEER CAN

Steps:

• Rinse chicken well inside an out.
• Pat bird completely dry with paper towels.
• To make the rub: mix 4 tbsp paprika, 2 tsp salt, 2 tbsp black pepper, 2 tsp cayenne pepper, and 1/4 cup brown sugar in a small bowl and set it aside.
• To make glaze: mix together 1/4 cup brown sugar, 4 tbsp ketchup, 3 tsp frank's red hot sauce, 4 tbsp white vinegar, 4 tbsp beer (save remainder in can and set it aside), and 2 tbsp of the spice rub you just made in a separate bowl; set aside.
• Pour beer can out (or drink it down) until it is just a bit over half way full and then add crushed bay leaves and 1 tsp of rub to the half full can.
• Loosen the skin on the breasts, legs and thighs of your chicken.
• Massage the rub into the meat under the skin and then all over the outside of the bird's skin as well as inside the cavity.
• Place beer can in the "butt" of the bird making the bird stand upright.
• Preheat grill with all burners on high until grill is heated and ready to cook.
• You must cook indirectly; so if you have 2 burners on your grill, turn one off (for 3 burners turn 1 off, for 4 burners turn 2 off, etc.).
• Place the standing bird on the cooler or "off" burner side of the grill with the breasts facing the hot or "on side of it (you grill should remain at about 375 degrees during the entire cooking process).
• Close lid and cook for 30 minutes, then rotate bird so that the opposite side (the back) is not facing the heated side of the grill and then continue cooking with the lid closed for 30 more minutes.
• Rotate bird back to original position with breasts facing the heat and glaze the entire bird thoroughly with the pre-made glaze; continue cooking 30 more minutes until cooked, brown and slightly crisped.
• Transfer chicken carefully off of beer can and onto cutting board.
• Let rest 5-10 minutes and then carve and enjoy!