12 Inch Pie Crust Recipes

PERFECT PIE CRUST

Steps:

• Mix the flour, sugar, and salt: Put flour, sugar, and salt into the bowl of a food processor and pulse a couple times to mix.
• Add the butter, half at a time, pulsing several times after each addition: Add about half of the butter to the food processor and pulse several times. Then add the rest of the butter and pulse 6 to 8 times until the largest pieces of butter are about the size of large peas.
• Slowly add the ice water: Sprinkle the mixture with 4 tablespoons of the ice water (make sure there are no ice cubes in the water!) and pulse again. Then add more ice water, a tablespoon at a time, pulsing once or twice after each addition until the dough just barely begins to hold together. You may not need all the water. The mixture is ready when a small handful of the crumbly dough holds together when you pinch it with your fingers.
• Make two dough discs: Carefully empty the crumbly dough mixture from the food processor on to a clean, dry, flat surface. Gather the mixture in a mound. Divide the dough mixture into two even-sized mounds. Use your hands and knead each mound just enough to form each one into a disc. Do not over-knead! Kneading develops gluten which will toughen the dough, not something you want in a pastry crust. You should just knead enough so that the dough holds together without cracks. If you started with cold butter you should be able to see small chunks of butter speckling the dough. This is a good thing. These small bits of butter will spread out into layers as the crust cooks so you have a flaky crust! Sprinkle each disc with a little flour, wrap each one in plastic wrap, and refrigerate for one hour or up to 2 days.
• Remove dough from refrigerator and let sit for a few minutes: Remove one crust disc from the refrigerator. Let sit at room temperature for 5-10 minutes in order to soften just enough to make rolling out a bit easier.
• Roll out dough, place in pie dish: Roll out with a rolling pin on a lightly floured surface to a 12-inch circle; about 1/8 of an inch thick. As you roll out the dough, check if the dough is sticking to the surface below. If necessary, add a few sprinkles of flour under the dough to keep the dough from sticking. Carefully place onto a 9-inch pie plate. Gently press the pie dough down so that it lines the bottom and sides of the pie plate. Use a pair of kitchen scissors to trim the dough to within 1/2 inch of the edge of the pie dish.
• Add filling to the pie
• Roll out second disc, place on top of filling: Roll out second disc of dough, as before. Gently place onto the top of the filling in the pie. Trim excess dough with kitchen shears, leaving a 3/4 inch overhang. Fold the edge of the top piece of dough over and under the edge of the bottom piece of dough, pressing together. Flute edges using thumb and forefinger or press with a fork. Score the top of the pie with four 2-inch long cuts, so that steam from the cooking pie can escape.
• Freeze the crust it for at least a half hour: until chilled. This is an important step in pre-baking. Otherwise the crust will slip down the sides. Preheat your oven to 350°F.
• Line pie crust with aluminum foil: When the pie crust is sufficiently chilled, line the pie crust with aluminum foil. Let the foil extend over by a few inches on two sides to make it easier to lift to remove the pie weights when the baking is done.
• Fill with pie weights: Fill the crust to the top with pie weights - dry beans, rice, or sugar. (Sugar works best.)
• Bake: Bake at 350°F for 45-50 minutes if making a crust for a pie that will require further cooking, for example a quiche. Bake for 60 to 75 minutes if making a crust for a pie that you don't need to bake further.
• Cool completely before filling: You may need to tent the edges of the pie with aluminum foil when you bake your pie, to keep the edges from getting too dried out and burnt. See more detailed instructions and photos for how to blind bake a crust here .
• Make the dough: Combine flour, salt, and sugar in a food processor; pulse to mix. Add the butter and pulse 4 times. Add shortening in tablespoon sized chunks, and pulse 4 more times. The mixture should resemble coarse cornmeal, with butter bits no bigger than peas. Sprinkle 6 tablespoons of ice water over flour mixture. Pulse a couple times. If you pinch some of the crumbly dough and it holds together, it's ready. If the dough doesn't hold together, keep adding water, a teaspoon at a time, pulsing once after each addition, until the mixture just begins to clump together.
• Form discs: Remove dough from machine and place in a mound on a clean surface. Divide the dough into 2 balls and flatten each into 4 inch wide disks. Do not over-knead the dough! Dust the discs lightly with flour, wrap each in plastic, and refrigerate for at least an hour, or up to 2 days before rolling out.
• Roll out the dough: After the dough has chilled in the refrigerator for an hour, you can take it out to roll. If it is too stiff, you may need to let it sit for 5-10 minutes at room temperature before rolling. Sprinkle a little flour on a flat, clean work surface and on top of the disc of dough you intend to roll out. (We use a Tupperware pastry sheet that has the pie circles already marked.) Using a rolling pin, apply light pressure while rolling outwards from the center of the dough. Every once in a while you may need to gently lift under the dough (a pastry scraper works great for this) to make sure it is not sticking. You have a big enough piece of dough when you place the pie tin or pie dish upside down on the dough and the dough extends by at least 2 inches all around.
• Place into pie dish: When the dough has reached the right size, gently fold it in half. Lift up the dough and place it so that the folded edge is along the center line of the pie dish. Gently unfold. Do not stretch the dough.
• If single crust pie: trim edges: If you are only making a single crust pie, use a pair of kitchen scissors to trim the dough to within 1/2 inch of the lip of the dish. Tuck the overhang underneath itself along the edge of the pie dish. Use your fingers in a pinching motion, or the tines of a fork to crimp the edge of the pie crust.
• If making double crust pie: roll the second crust: If you are making a double crust pie, roll out the second disc of dough. Gently place onto the top of the filling in the pie. Use a kitchen scissors to trim the overhang to an inch over. Fold the edge of the top piece of dough over and under the edge of the bottom piece of dough, pressing together. Finish the double crust by pressing against the edges of the pie with your finger tips or with a fork.
• Make vents in the top: Use a sharp knife to cut vents into the top of the pie crust, so the steam has a place to escape while the pie is cooking. Before scoring, you may want to paint the top of your crust with an egg wash (this will make a nice finish).
• Beat egg yolk with cream and brush on the surface of the pie with a pastry brush.

PATE BRISEE TO MAKE ONE DOUBLE-CRUST 10-INCH PIE OR 12 HAND PIES

Steps:

• In the bowl of a food processor, combine flour, sugar, and salt; pulse to combine. Add butter, and pulse until mixture resembles coarse crumbs with some larger pieces remaining, about 10 seconds. (To mix by hand, combine dry ingredients in a large mixing bowl, then cut in butter with a pastry blender.)
• With the machine running, add ice water through the feed tube in a slow, steady stream, just until dough holds together without being wet or sticky. Do not process more than 30 seconds. Test by squeezing a small amount of the dough together; if it is still too crumbly, add a bit more water, 1 tablespoon at a time.
• Turn out dough onto a clean work surface. Divide in half, and place each half on a piece of plastic wrap. Shape into flattened rectangles. Wrap in plastic, and refrigerate at least 1 hour or overnight.

BASIC FLAKY PIE CRUST

Steps:

• Whisk the flour and salt together in a medium size bowl. With a pastry blender, cut in the cold shortening until the mixture resembles coarse crumbs. Drizzle 2 to 3 tablespoons ice water over flour. Toss mixture with a fork to moisten, adding more water a few drops at a time until the dough comes together.
• Gently gather dough particles together into a ball. Wrap in plastic wrap, and chill for at least 30 minutes before rolling.
• Roll out dough, and put in a pie plate. Fill with desired filling and bake.

PASTRY FOR EXTRA-LARGE DOUBLE-CRUST PIE

Steps:

• In a bowl, combine flour and salt; cut in shortening until crumbly. Gradually add water, tossing with a fork until dough forms a ball. Divide dough in half so that one ball is slightly larger than the other. Roll out larger ball to fit an 11-1/2-in. to 12-in. pie plate. Transfer pastry to pie plate; trim even with edge of plate. , Pour desired filling into crust. Roll out second ball; cut slits in pastry. Position over filling. Trim pastry to 1 in. beyond edge of pie plate. Fold top crust over bottom crust. Flute edges. Bake according to recipe directions.

TWO CRUST PIE, 10 INCHES

Steps:

• Mix flour and salt. Cut in the shortening until particles are the size of peas.
• Sprinkle with the water, 1 tablespoon at a time, tossing with a fork until all the flour is moistened and the pastry almost cleans the side of the bowl. Additional water can be used if necessary.
• Divide pastry into 2 equal parts. Gather each portion into a ball.
• Working with one ball at a time: flatten into a disk on a lightly floured surface. I place my pastry between sheets of plastic wrap or wax paper - which makes it easier to lift onto the pie pan.
• Roll the pastry into a circle that is 2 inches larger around than the inverted pie pan. Carefully ease the pastry into the pan and press it firmly against the bottom and sides.
• Pour in the pie filling and then cover with the remaining pastry. Remember to cut slits in the top to allow steam to escape. Bake according to pie recipe directions.

PASTRY FOR PIES AND TARTS

Steps:

• One-Crust Pastry: In medium bowl, mix flour and salt. Cut in shortening, using pastry blender or fork, until mixture forms coarse crumbs the size of small peas. Sprinkle with water, 1 tablespoon at a time, tossing with fork until all flour is moistened and pastry almost leaves side of bowl (1 to 2 teaspoons more water can be added if necessary). Gather pastry into a ball. Shape into flattened round on lightly floured surface. Wrap flattened round in plastic wrap and refrigerate 45 minutes or until dough is firm and cold, yet pliable. This allows the shortening to become slightly firm, which helps make the baked pastry flaky. If refrigerated longer, let pastry soften slightly at room temperature before rolling. Using floured rolling pin, roll pastry on lightly floured surface (or pastry board with floured pastry cloth) into round 2 inches larger than upside-down 9-inch glass pie plate or 3 inches larger than 10- or 11-inch tart pan. Fold pastry into fourths and place in pie plate or tart pan, or roll pastry loosely around rolling pin and transfer to pie plate or tart pan. Unfold or unroll pastry and ease into plate or pan, pressing firmly against bottom and side and being careful not to stretch pastry, which will cause it to shrink when baked. For pie, trim overhanging edge of pastry 1 inch from rim of pie plate. Fold edge under to form standing rim; flute edges (see Decorative Crust Ideas, page 00). For tart, trim overhanging edge of pastry even with top of tart pan. Fill and bake as directed in pie or tart recipe.
• Two-Crust Pastry: In medium bowl, mix flour and salt. Cut in shortening, using pastry blender or fork, until mixture forms coarse crumbs the size of small peas. Sprinkle with water, 1 tablespoon at a time, tossing with fork until all flour is moistened and pastry almost leaves side of bowl (1 to 2 teaspoons more water can be added if necessary). Gather pastry into a ball. Divide pastry in half and shape into 2 rounds on lightly floured surface. Wrap flattened rounds in plastic wrap and refrigerate 45 minutes or until dough is firm and cold, yet pliable. This allows the shortening to become slightly firm, which helps make the baked pastry flaky. If refrigerated longer, let pastry soften slightly at room temperature before rolling. Using floured rolling pin, roll one round of pastry on lightly floured surface (or pastry board with floured pastry cloth) into round 2 inches larger than upside-down 9-inch glass pie plate. Fold pastry into fourths and place in pie plate, or roll pastry loosely around rolling pin and transfer to pie plate. Unfold or unroll pastry and ease into plate, pressing firmly against bottom and side and being careful not to stretch pastry, which will cause it to shrink when baked. Spoon desired filling into bottom crust. Trim overhanging edge of bottom crust 1/2 inch from rim of plate. Roll out second pastry round. Fold into fourths and place over filling, or roll loosely around rolling pin and place over filling. Unfold or unroll pastry over filling. Cut slits in pastry so steam can escape. Trim overhanging edge of top pastry 1 inch from rim of plate. Fold edge of top crust under bottom crust, forming a stand-up rim of pastry that is even thickness on edge of pie plate, pressing on rim to seal; flute edges (see Decorative Crust Ideas, page 00). Bake as directed in pie recipe.